Model #PV-1350 Panasonic vcr

  • No Image Available - Fidelitone
    3 Results

Question and Answers


Auger will not stop when handle released on Craftsman 1350 snow series


Thank you for your question.  I am sorry you are having a problem with the snow blower. If the auger will not fully disengage when you release the handle, I suspect the problem is with the return spring. This snow blower has a return spring that applies a brake when you release the handle. I recommend checking the spring first. To do that you need to tip the snow blower onto its nose. Then remove the access panel on the bottom of the snow blower. Once removed, look for the return spring. The spring should be connected on the end of the idler arm on one end and to the frame on the other. The image below shows the Idler spring. Just click on the image to enlarge it.  I hope this is helpful. Please let me know if you need further assistance.   Thank you for using Manage my life.Mark

Read More
Mark T -
Sears Technician
February 14, 2013

Why won't the bake element glow red?


During the baking mode the bake element is going to cycle ON and OFF during the preheat mode. The bake element will be ON for 25 seconds per minute and the broil element will be ON for 15 seconds per minute. NOTE: The bake element is not going to glow red within the 25 seconds of being powered up while preheating. Be sure to give it plenty of time to pre-heat before assuming the oven will not reach the set temperature.


Baking mode:

First rise (preheat): Bake element is on 25 seconds per minute. Broil element is on 15 seconds per minute. Convection element is on 20 seconds per minute. The convection fan is on all the time but it stops once the set temperature has been reached. Normal baking: The EOC will cycle through the bake element and broil element to maintain the set temperature. Broiling mode Broil element is on for 60 seconds per minute.

When you checked the voltage supply across the Orange and Yellow wires did you leave the wires connected to the Bake element? You should always check the voltage while under a load. The voltage can drop when under load so don't check the voltage across the Orange and Yellow wires while disconnected from the Bake element. Leave the Orange and Yellow wires connected to Bake element when checking the voltage at the Bake element. If you measure 240volts while connected to the bake element and the element begins to heat then the bake element is likely OK based on your resistance reading and voltage reading. If don't measure 240 volts across the Orange and Yellow wires while connected to the Bake element, the oven control board has likely failed.

If your unable to diagnose the failure I recommend calling a service technician.

Read More
Joey S -
Sears Technician
December 10, 2009

Kenmore 90 Gas Dryer Not Heating


Hi Mike,

Thank you for submitting a question to Manage My Life.

I am sorry you are having problems with your dryer.

From the description you gave and the readings that you corrected, it sounds like the gas valves are bad. I would recommend you replace them. Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts. Here is a link that you may use for parts purchases; Valve coil kit .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Thanks again for using Manage My Life.


Read More
Landell -
Sears Technician
July 11, 2011