Model #POWER STRIPPER Wagner power stripper

  • Power Stripper
    3 Results

Question and Answers

Q:

Why are the ice cubes jamming between the ejector and stripper on my ice maker?

A:

The ice cubes are likely jamming because they are a smaller size due to a water pressure or flow problem. Check the pressure and flow from the water dispenser on the front of the freezer door. If it is flowing normally, then you could have a clogged or frozen fill tube that supplies water to the ice maker. Check the fill tube that protrudes through the top inside left corner of the freezer. You may have to unplug the refrigerator and pull the ice maker out to check this area. If the fill tube is frozen, you can defrost it and the ice maker should fill and operate properly. You could also have a build up of hard water deposits or a clog in the water fill line going to the ice maker. A bad water solenoid fill valve could also cause this problem.

If the water dispenser pressure and flow is low, then I recommend shutting off the water supply and disconnecting the water supply line on the back of the refrigerator. Place the end of the line in a bucket and open the shut-off valve briefly to check the pressure and flow from the supply line to the refrigerator. If it has low pressure and or flow, then this is what is causing your ice maker problems. You may need to have a plumber fix this water supply problem.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
August 20, 2009
Q:

How do I replace the ice stripper part #2182124?

A:

Without knowing the model number of your Kenmore refrigerator I will not be able to provide any model specific information or instructions, only general. The ice maker will need to be taken out from the freezer. Depending on the model, it normally will have 3 screws securing it to the side wall. Remove the screws and then disconnect the ice maker wire harness. Remove the square plastic cover. You may have to pry it off using a flat tipped screw driver. Be sure to slide it straight off or it will bind. After removing the cover, remove the two mold attachment screws hidden past the two access ports using a Phillips head screwdriver as shown in the image below. After un-threading the two screws, pull the module base away from the mold enough to slide and disengage the ice stripper at the back of the mold. Reverse the procedure to install the new stripper.

Read More
Joey S -
Sears Technician
April 06, 2010
Q:

refrig model # 10654589400 ice stripper rotates entire way aroung how to replace this part

A:

The easiest way to fix this problem is to replace the entire ice maker assembly (part W10190965). You can order that part from the Sears PartsDirect website. Here is a direct link for that part: Ice Maker .

If you do want to diagnose and fix the ice maker instead of replacing the whole assembly, I recommend that you view this repair video: Ice Maker Repair . That video will show you the internal components and how they work. This will help you disassemble and replace components inside that ice maker assembly. NOTE: The cost of the module is higher than the cost of the entire ice maker assembly. If you need that part, you will probably be better off replacing the entire ice maker assembly as recommended above.

If you need more help, reply with additional details and we will assist you further.

If you get to a point where you need to have a service technician diagnose and repair this failure, you can schedule one through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 05, 2012