Model #PE550 TYPE 1 Weed Eater edger

  • Handle/fan Housing/gear Box
    3 Results
  • Cylinder/crankshaft/crankcase
    3 Results
  • Carburetor #530069654 (wt308)
    3 Results
  • Service Reference
    3 Results

Question and Answers

Q:

3 in 1 Lawn Tractor blade type

A:

Thank you for your question.

The 3 in 1 blade is used for mulching, bagging, and side discharge. We have used this blade for years and it work good for all 3.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
May 15, 2012
Q:

Compression on 2 stroke gas edger Weedeater PE550

A:

I don't have compression specifications for the engine on that type of edger. Generally speaking, a compression of 60 PSI is the minimum that is needed for the engine to start.

Read More
Lyle W -
Sears Technician
May 09, 2013
A:

That 60 PSI is the lower threshold limit of compression needed for a typical 2-cycle engine. Most engines will start with 60 PSI of compression but it may not run very well if you do get it started. If it is getting a good supply of gas and an adequate spark, then it should at least start.

Read More
Lyle W -
Sears Technician
May 09, 2013
See more answers
Q:

Type 1 conversion kit / parts list Model# 790.74403995

A:

A qualified installer should convert this range back to natural gas. The LP conversion kit instructions normally have information on the how to convert the range back to natural gas from propane. I do not have a copy of those instructions. I will try to get those instructions from the manufacturer. Once I receive those instructions, I should be able to provide the installer with some assistance in converting this range back to natural gas.

I will update this thread as soon as I receive the LP conversion kit instructions from the manufacturer.

Read More
Lyle W -
Sears Technician
November 30, 2011
A:

Hello David. I just received the LP conversion kit instructions from the manufacturer. Those LP conversion kit instructions included a section for converting the range back to natural gas. The first 3 pages shown below have the information for converting this range back to natural gas. The instructions show the sizes of the orifices that are needed for that natural gas conversion. I do not see those individual orifices listed through the parts diagram on our Sears PartsDirect.com website. I recommend that you check with your gas company or a local appliance parts supplier in your local area to obtain those natural gas orifices (unless you can find the ones that were originally installed in the range). In the 4th image below, I provided the sizes of Propane (LP) orifices that were installed during the conversion. That information should help you with the configuration of the natural gas orifices on the burners. I hope that this information will help your installer properly convert this range. If you need more assistance, reply with additional details.

Read More
Lyle W -
Sears Technician
December 01, 2011
A:

Here is the 4th image that shows the LP (Propane) orifices that were used on the conversion.

Read More
Lyle W -
Sears Technician
December 01, 2011
See more answers