Model #MVWX500XW0 Maytag residential washers

  • Top And Cabinet Parts
    3 Results
  • Console And Dispenser Parts
    3 Results
  • Basket And Tub Parts
    3 Results
  • Gearcase, Motor And Pump Parts
    3 Results
  • Optional Parts (not Included)
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Maytage model MVWX500XW0 won't fill

A:

Thank you for your question as to why the washer will not fill with water.

This washer has a load sensor system and does not fill when it first starts. It has procedure it goes through to weight sense the load before it starts putting water in.

I would suggest that you let it run for 5 minutes to see it will put water in to the machine.

If it still does not fill it could be a faulty water inlet valve.

It is possible that the wires may have been pulled loose or some damaged occurred to the water valve when you laid it on its side instead of standing up.

My best advice at this time is to have a technician out to see what the problem is.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

If you choose not to have a technician look at the washer please let me know what you have found, and we can continue our troubleshooting based on that.

Sam A.

Read More
Sam A -
Sears Technician
August 17, 2011
Q:

washer discharge hose extension MVWX500XW0

A:

Thank you for your question and I understand your concern.

If the drain hose is too short, there is a kit which is part # 280131 but substitutes to part #40922 which is also shown on page 2 in the installation instructions.

The extension hose kit #40922 can be ordered from Sears Parts Direct.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
January 11, 2013
Q:

wah plate MVWX500XW0 Maytag Automatic washer

A:

You could have a problem with the actuator motor in that drive system. That actuator may not be shifting the splutch between the agitation position and the spin position properly.  You can view all of the components in the drive system from the bottom of the washer. Unplug the washer and shut off the water supply. Remove the fill hoses and carefully lay the washer down on the front panel. Use cardboard on the floor to prevent scratching that front panel. Here is a link for a previous answer that provides some images and technical information about the drive system in that washer: http://www.managemylife.com/mmh/questions/333823-kenmore-washer-model-11026002010 .

 

Examine those drive components and order any parts that are worn or damaged. If you need more help, reply with additional details and we will assist you further. 

Read More
Lyle W -
Sears Technician
November 07, 2013