Model #MGR4452BDW Maytag free standing, gas

  • Body
    3 Results
  • Control Panel/top Assembly
    3 Results
  • Door/drawer
    3 Results
  • Door/drawer (series 13)
    3 Results
  • Gas Controls
    3 Results
  • Oven/base
    3 Results
  • Supplemental Info/no Image Available
    3 Results
  • Wiring Information
    3 Results

Question and Answers

Q:

How do I fix my Maytag oven model MGR4452BDW when the temperature "up" button will not work?

A:

Based on your symptom the electronic oven control board has failed and it will need to be removed and replaced.

I added the instructions in the image below. You will see that it takes a special tool to remove the burner caps. You may be able to twist the sealed burner/cap off using you hand. I recommend calling a service technician to remove and replace the electronic oven control board.

Since I do not know what color the clock/oven control is I added all the available colors and part numbers below.

Oven control board color and part#:

  • White-- #74010453
  • Bisque--#74009881
  • Black--#74009908

Read More
Joey S -
Sears Technician
January 12, 2010
Q:

Conversion Kit on Maytag range.

A:

Thank you for your question on the LP conversion.

I have given you the instructions below in the image.

Gas appliances are inherently dangerous when servicing this function on the range. We advise that you have you LP gas provider do the conversion a subsequent leak check to make sure the range is safe to use.

I hope this information will help you with your conversion.

Thank you for using Manage My Life.

Sam A.

Read More
Sam A -
Sears Technician
August 01, 2011
Q:

I have a maytag range mod#mgr4452bdw, serial# 14421135jr. I was informed by a repair guy that I need to eplace my silinod valve. I need to replace the part.

A:

Thank you for your question and I understand your concern.

I believe the part you are referring to is the safety valve (key#9) as shown on the gas control page of the parts diagram but I don't believe that's the problem. The problem is more likely the oven ignitor (key#14). If the oven ignitor does not pull enough current/amperage the safety valve will not open or it may open and then close if the ignitor is right on the edge of being too weak to pull enough current/amperage.

The ignitor must pull between 3.2 and 3.6 amps in order to open and keep the oven safety valve open. You will need a clamp on amperage meter to measure the amperage draw of the ignitor.

NOTE: Disconnect the power cord before removing and replacing the bake ignitor. I added a couple of images below. The first image has the basic instructions on how to access the bake burner and bake ignitor. The second images is of the parts.

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
August 23, 2011