Model #MFW9600SQ0 Maytag residential washers

  • Top And Cabinet Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Dispenser Parts
    3 Results
  • Tub And Basket Parts
    3 Results
  • Pump And Motor Parts, Optional Parts (not Included)
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

control lock will not release so I can use my washer could it be that the water is shut off canthat cause it to lock

A:

Thank you for your question and I understand your concern.

To unlock the control panel; press and hold the "Cycle End Signal" button 3 seconds or longer until the "Control Locked" light turns off. The "Control On" button will not likely come on if the "Control Locked" light is lit. The control would likely just beep 3 times indicating you can't turn the control panel ON until you take it out of "Control Locked".

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
July 28, 2011
Q:

my maytag washer is still on conrol lock after the repairman you sent to fix my dryer left Model mfw9600sq0

A:

Thank you for your question and I understand your concern.

You should be able to unlock the control by pressing and holding the "Cycle End Signal" button until the "Control Locked" light turns off. You may have to push and hold it longer than 3 seconds before it the "Control Locked" light turns off.

If you're not able to unlock the control then it may need a new User Interface board.

Read More
Joey S -
Sears Technician
July 26, 2011
Q:

Why is my 2 year old front loading washer leaking underneath?

A:

Check the fill hoses in the back of the washer to see if they are leaking. Make sure that they are properly connected.

Check the drain hose to make sure that it is properly inserted in the stand pipe. Make sure that the drain is working properly.

Open the door and check the rubber door boot for tears or cracks. Make sure that it is securely attached to the tub and the front panel door opening.

Unplug the washer and remove the bottom front service panel as shown in the image below. Check the drain pump and the hoses attached to it for signs of leaking.

Using these tips, you may be able to determine the source of your leak. If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
April 16, 2009