Model #MDBH969AWS2 Maytag dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel And Latch Parts
    3 Results
  • Inner Door Parts
    3 Results
  • Fill, Drain And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Heater Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Lower Rack Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Optional Parts (not Included)
    3 Results

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

My maytag ( MDZBH969AWS2) dishwasher is not completing the cycle. The machine will not work and I have two lights on the control panel that will not turn off. P

A:

Thank you for your question and I understand your concern.

 You did not state which two lights are on. I also will need to know if the two lights are flashing or not.

If the two lights are flashing, then it likely has a faulty key pad/control panel assembly.

The control panel/key pad ribbon connector will need to be disconnected from the control board and then an Ohm meter will be needed to test the key pad/control panel.

I added an image below with the procedure of testing the key pad. NOTE: Disconnect the dishwasher from the power supply before servicing. 

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

 

Read More
Joey S -
Sears Technician
August 14, 2013

Recommended maintenance parts & accessories

Show 3 more
No more item to show