Model #MC-V6975 Panasonic vacuum, upright

  • Vacuum Cleaner/specifications
    3 Results
  • Table Of Contents
    3 Results
  • Pictorial Wiring Diagram
    3 Results
  • Exploded View/general Parts
    3 Results
  • Exploded View/nozzle Housing
    3 Results
  • Exploded View/agitator
    3 Results
  • Exploded View/body
    3 Results
  • Exploded View/body Page 2
    3 Results
  • Exploded View/handle
    3 Results
  • Exploded View Motor Case/fan
    3 Results
  • Exploded View Packing Materials
    3 Results
  • Lower Plate/headlight Bulb
    3 Results
  • Agitator /belt Replacement
    3 Results
  • Nozzle Housing/hose Replacement
    3 Results
  • Power Cord/on-off Switch Replacement
    3 Results
  • Dirt Sensor Diagnosis
    3 Results
  • Suction Inlet/hose/motor Replacement
    3 Results
  • Motor/carbon Brush Replacement
    3 Results
  • Fan Replacement
    3 Results

Question and Answers

Q:

I have a Kenmore canister vacuum. Need to install new Hepa media filter. Which way does it go in? What direction should the black arrow point? Up or down?

A:

Thank you for your question.

I can understand wanting to know which direction to install the filter.

You always put the filter in with the arrows pointing the direction of the air flow.

The filter arrow should be pointing out on this model.

I have given you a picture of the proper filter replacement procedure.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
March 01, 2011
Q:

What should the amp reading be on the model mc 2100 controller on my treadmill?

A:

I am sending you a wiring schematic of the treadmill that shows the voltages at the controller. To test to see if you are getting voltage on the blue wire from the console, the connector has to be connected to the controller when testing.

I am also sending you an image of the MC2100 controller that gives some error codes that might help you.

Read More
Jimmy K -
Sears Technician
January 14, 2010
Q:

What should the amp reading be on the model mc 2100 controller on my treadmill?

A:

I am sending you a wiring schematic of the treadmill that shows the voltages at the controller. To test to see if you are getting voltage on the blue wire from the console, the connector has to be connected to the controller when testing.

I am also sending you an image of the MC2100 controller that gives some error codes that might help you.

Read More
Jimmy K -
Sears Technician
January 14, 2010