Model #MARK XXII Smith Corona business system centers

  • Jackets
    3 Results
  • Transformer
    3 Results
  • Keyboard
    3 Results
  • Keybutton Reference Chart
    3 Results
  • Carrier Molding, Rails, & Frames
    3 Results
  • Carrier Drive
    3 Results
  • Element Drive
    3 Results
  • Ribbon Drive
    3 Results
  • Ribbon Cassette & Correction Cassette Mechanism
    3 Results
  • Hammer
    3 Results
  • Paper Feed
    3 Results
  • Control Pc Board
    3 Results

Question and Answers

Q:

Posted to Mark (expert) Does Mark Get An Email?

A:

Thank you for your question.

I am sorry I did not get the response you have posted. If the new pinion did not help, I suggest checking the shaft from the gearbox. I have only seen the shaft break a handful of times. You will need to use caution when doing this. First, remove the spark plug wire. Then hold the bail down and pull the drive lever. With these held pull on the starter rope. When the engine turns over the shaft should be turning. If they were turning, I would say the problem is in the pinions or the wheels have worn teeth. I think you would have noticed that. Used the images below to inspect the pinions. If they look ok, you can use some graphite powder to help keep the parts moving free.

If the new pinion is not working you can call the parts department for an exchange. The number should be on the packing list that came with the parts.

I have double checked the alerts for this question so i should be notified if you respond.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
June 21, 2011
Q:

Why won't the selector knob mark the selection?

A:

The likely failure is the "PCB" control board.

I recommend calling a service technician in order to properly diagnose and repair your microwave. We do not assist consumers working on microwaves for safety concerns. The microwave can store 15,000 volts of electricity even when the microwave is unplugged from the power source which can be lethal.

Read More
Joey S -
Sears Technician
March 04, 2009
Q:

Question for Mark T.

A:

Thank you for your question.

On most chainsaws, you have to remove the clutch to replace the oiler. If you do not have a clutch removal tool you can use a punch and hammer to loosen the clutch. To keep the engine from turning remove the spark plug and feed some soft rope into the hole. This will keep the engine from turning while you tap on the clutch. I have found a video that shows how remove the clutch.

Please click here to watch the video.

Here is a link to order any parts you need. Sears Parts Direct .

Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
April 08, 2011