Model #MAH4000AWQ Maytag residential washers

  • Control Panel
    3 Results
  • Top
    3 Results
  • Cabinet-front
    3 Results
  • Cabinet-rear
    3 Results
  • Door & Front Panel
    3 Results
  • Door Shroud & Door Latch Assembly
    3 Results
  • Outer Tub
    3 Results
  • Spinner Assembly & Outer Tub Cover
    3 Results
  • Base
    3 Results
  • Wiring Information (series 10)
    3 Results
  • Wiring Information (series 11)
    3 Results
  • Wiring Information (series 45+)
    3 Results
  • Motor & Motor Control
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Maytag washer with blown control board.

A:

Hi Ben,

Thank you for submitting a question to Manage My Life.

When a control board goes bad multiple times it is time to start looking for a cause. This type of washer has been known to have issues with other components taking the control out. I recommend looking at the control board for burnt resistors and then using the chart I am including in the images below. Then, if one of the resistors is burnt follow the corrective action listed for that resistor.Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website; Sears Home Services .

Here is a link that you may use to view the parts list diagram or to purchase any parts needed for your Maytag model number MAH4000AWQ washer .

I hope this is helpful. Check the things I have covered here and if I may be of further assistance please reply to this post.

Landell

Read More
Landell -
Sears Technician
March 26, 2012
Q:

DOOR WILL NOT LOCK ON MY MAYTAG WASHER

A:

Hi Todd,

Thank you for submitting a question to Manage My Life.

I am sorry you are having problems with your washer.

This washer does not lock until 3 minutes after a wash cycle is started. If your door is coming open before the 3 minutes is up, you may have a bad latch assembly or you may be overloading the washer. I recommend replacing the latch assembly first.

Here is a link that you may use for parts purchases Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Thanks again for using Manage My Life.

Landell

Read More
Landell -
Sears Technician
May 27, 2011

Recommended maintenance parts & accessories

Show 3 more
No more item to show