Model #MAC 3516 11-600035-10 Mcculloch chainsaw, gas

  • General Assembly
    3 Results
  • Powerhead Assembly
    3 Results
  • Chain Brake Assembly
    3 Results
  • Carburetor Assembly
    3 Results
  • Bar And Chain Chart - Text Only
    3 Results
  • Specifications- Text Only
    3 Results

Question and Answers

Q:

McCulloch MAC 160S Chainsaw

A:

Thank you for your question.

 

I am sorry you are having a problem with the chain saw. If the chain will not tighten when you loosen the nuts and turn the adjusting screw, I suspect the adjustment pin on the clutch cover is broken or not positioned in the bar. I found a video that shows how to replace the adjustment pin. The video also shows how the pin should fit into the bar. Click here to watch the video. 

 

I hope this is helpful. Please let me know if you need further assistance.

 

 

 

 

Thank you for using Manage my life.

 

Mark T.

Read More
Mark T -
Sears Technician
November 05, 2013
Q:

I bought a Maytag front loading washing machine on 11/06/10. Its a 2000 series and it sounds like an airplane when its in the spin cycle.

A:

Hi Vicki,

Thank you for submitting a question to Manage My Life. I am sorry you are having problems with your washer.

I looked at your previous question and I agree with Joey. This is most likely an issue with the bearings. And, as Joey stated, we cannot look at specific information for your washer without the model number. The model number should be located inside the loading door or on the back panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram and for parts purchases; Sears Parts Direct .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Landell

Read More
Landell -
Sears Technician
November 28, 2011
Q:

Craftsman Vertical Ban Saw #112.235851 runs for 10 minutes and cuts off, I wait about 1 to 11/2 minutes and it can turn back on.

A:

Thank you for your question.

I am sorry you are having a problem with the saw. I recommend removing the blade first. Then start the saw and see how long the motor runs. If it still quits I recommend removing the drive belt and test it again. If the motor does not stop, I recommend looking for something binding in the pulleys and drive wheel. If the motor still quits I suspect the problem is a defective motor. If you have a volt ohmmeter, you can verify the motor is getting 120 volts before you condemn it.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
January 25, 2012