Model #LT-P266W Samsung lcd television

  • Cabinet Parts
    3 Results

Question and Answers

Q:

LT 2000

A:

Thank you for your question on the choke setting on the tractor.

If it has the single throttle control there is a detent for the full throttle setting.

Pushing past this detent setting is when the choke is activated and the end of the travel of the throttle control. So this means you will have to go past the rabbit to as far as the handle will let you.

I hope this will help.

Sam A.

Read More
Sam A -
Sears Technician
August 24, 2012
Q:

safety switch on lt 1000

A:

Thank you for your question.

Your Tractor uses an Operator Presence (seat) switch that will cause engine to stall if blades are engaged or the brake is released without anyone on the seat. If ample amount of weight is not kept on the seat during operation or the operator is leaning forward the tractor will stall because the Operator Presence (seat) switch senses that the operator is not completely on the seat.

To check Operator Presence (seat) switch:

  1. Lift seat.
  2. Locate wires that connect to Operator Presence (seat) switch under the seat.
  3. Disconnect and clean any debris in the switch connector. Use an ohmmeter to check the switch. When the switch is not pushed, the reading should be 0 ohms (closed). When pushed it should read ol ( open load )
  4. Make sure the connector is fully seated on the seat switch. The connector is a special connector that will short the two wires if it is not fully seated.

I hope this is helpful.

Please click on the following link to order the parts you need. Sears Parts Direct

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Please let me know if you need further assistance.

Thank you for using Mange my life.

Mark T.

Read More
Mark T -
Sears Technician
April 12, 2011
Q:

PTO on Craftsman LT 1500

A:

Thank you for your question.

I am sorry you are having a problem with the tractor. The deck on your tractor is engaged with a cable. With the engine turned off have someone engage and disengage the mower while you watch the cable and the idler arm. The cable pulls on the spring that pulls the idler to tighten the belt. If the cable stretches the spring but does not move the idler, I suspect the pivot point on the idler is rusted. Usually spraying the area down with WD-40 and work it back and forth. I hope this is helpful.

Please let me know if you need further assistance.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
May 17, 2011