Model #L-150 Ryobi planer

  • Hand Planer
    3 Results

Question and Answers

Q:

kenmore ultrasoft 150 water softner,

A:

Carol,

The water softener should have about two inches of water in the bottom of the salt tank. If there is more than that in the salt tank, I recommend cleaning the nozzle venturi first. I posted an image below that shows how to clean the nozzle venturi. Then remove the cover of the brine well on the right side of the salt tank. You need to be sure the float assembly is pushed down to the bottom of the brine well. If it is not, the water will be higher than normal. After it is clean, it could take a few cycles for the water level to get back to normal.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage My Life!

Mark T.

Read More
Mark T -
Sears Technician
September 09, 2012
Q:

hooking up electrica l need schimatic

A:

I provided an electrical schematic for this washer in the first image below. NOTE: This information is intended for technicians. Follow electrical safety guidelines when using this data. Unplug the washer to disconnect electrical power before accessing internal components.

I provided some basic access information for this washer in the second image.

You can view a parts diagram and order parts from the Sears PartsDirect website if needed.

I hope that this is the information that you are looking for. If you need more help, reply with additional details and we will assist you further.

If you need a technician to repair the washer, you can schedule one through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
May 16, 2011
Q:

Code L 72180032700

A:

Thank you for your question and I understand your concern.

The letter "L" will display if the Child Lock feature is turned on.

This feature is used to lock the control panel when you are cleaning the oven, or so that children cannot use the oven when not supervised. This is explained in the Owner's Manual on page 13.

To cancel the "Child Lock" feature, touch and hold "START" until the "L" disappears in the display. 

This may be the issue. If not, please reply and I will be glad to assist you further. 

Read More
Joey S -
Sears Technician
October 15, 2013