Model #JGSP44WEY4WW Ge slide-in range, gas

  • Control Panel & Cooktop
    3 Results
  • Body Parts
    3 Results
  • Door
    3 Results
  • Door Lock
    3 Results
  • Surface Burner
    3 Results
  • Oven Burner
    3 Results

Question and Answers

Q:

my 13 year old sears GE Profile oven will not go past 100 degrees when I enter 325 degrees. Is this a repairable problem...I do not have an extended warranty.

A:

You may be able to diagnose and repair this problem yourself. The first image below shows the theory of operation for the ignition system in this model of range. The second image shows how to access the igniter and the burner in the oven. Since the oven is heating slightly, it is likely that the igniter is glowing but the oven burner is not lighting. This type of problem points to a weak igniter. I recommend that you pull the oven bottom out as shown in the second image. Verify that the igniter is glowing. See if the burner will ignite at all when the igniter is glowing. If not, then I recommend that you check to see if the broil burner will ignite properly. If the broil burner works, you can switch the bake and broil igniters and see if the bake burner will ignite properly. If the bake burner ignites with the broil igniter in place, then you will need to replace the defective igniter (part WB13T10001). You can order that part from the Sears PartsDirect website. Here is a direct link for that part: Igniter .

If the igniter is not no glowing or it cycles off quickly, then you could have a problem with the control board, the temperature sensor or the safety gas valve. The third image shows the access information for the control board and a wiring diagram for the range. The 4th image shows the procedure for accessing the temperature sensor probe in the oven. If the oven is lighting properly but not maintaining the proper temperature, you can shut off the house circuit breaker for the range and access the temperature sensor as shown in the 4th image. Check the resistance of that component using a volt/ohm meter. It should measure around 1100 ohms at room temperature. If the resistance is over 1200 ohms, then the sensor will probably need to be replaced. If the sensor is okay, you may need to replace the control board.

This information should help you determine the cause of your oven failure. If you need more assistance, reply with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 03, 2011
A:

Here is the 4th image.

Read More
Lyle W -
Sears Technician
January 03, 2011
See more answers
Q:

finding person to re-porcelin oven stove part

A:

I checked for any sources for a valid replacement part. I did not find that oven bottom available. You can check your local area for a service provider that will refinish porcelain appliance parts. I recommend conducting a web search using Google or a similar search engine. Check the BBB for references if you find a service provider in your area that will refinish that oven bottom.

Read More
Lyle W -
Sears Technician
April 13, 2012

Top Parts