Model #ICF-34 Sony portable audio

  • Cabinet Assembly
    3 Results

Question and Answers

Q:

How do I get the saw to change the angle of the miter cut? 8323 Tradesman Miter saw

A:

Thank you for your question and I understand your concern.

In order to change the angle of the miter cut you will need to loosen the locking handle knob, push down on the lock lever above the locking handle knob and then the table should rotate. If it does not rotate, the table is likely jammed. I added an image below to reference. 

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
May 01, 2013
Q:

Why does the rinse aid holder empty after only 3-4 washes on the dishwasher?

A:

Under normal conditions, rinse aid should last 1-3 months.

The dispenser must be leaking the rinse aid to be empty after 3-4 washes. If it's empty after 3-4 washes you should be able notice a small trail of rinse aide trickling down the inner door panel. In order to correct this problem the dispenser assembly will need to be replaced.

I recommend calling a service technician to remove and replace the dispenser assembly.

Read More
Joey S -
Sears Technician
May 29, 2008
Q:

Why is my GE refrigerator at 46 degrees when it is set for 34 degrees?

A:

The proper way to test refrigerator temperature is to fill a glass with water and place it on the center of a middle shelf in the refrigerator side. Allow 24 hours for the water to cool and then check the temperature of the water. With the refrigerator side set at 34 degrees, you should be close to that temperature.

The model number that you submitted looks slightly off. I suspect that you have a GSS25TSTBSS instead of a GS25TSTBSS. The model number GS25TSTBSS is invalid. You may have just left out the second S.

If the refrigerator is not cooling properly, make sure that the air vents injecting cold air into the refrigerator from the freezer are not blocked (see air flow diagram below).

Check the refrigerator door seals for cracks or loose spots. Make sure that the flapper of the ice dispenser on the freezer door is shutting properly. Frost or warm air leaking into the unit could inhibit cooling in the freezer and or the refrigerator.

Look for excessive frost build up in the freezer, especially on the back inside wall. This could indicate an automatic defrost system problem. Poor air circulation into the refrigerator side could result.

Make sure that the light in the refrigerator is turning off by pressing in on the light switch to simulate the closing of the refrigerator door. If the light in the refrigerator stays on constantly, it could affect cooling.

If the above tips do not help, you could have a control problem or a failure of the damper assembly that regulates cold air entering the refrigerator from the freezer. I recommend calling a service technician to diagnose and repair this type of problem.

If you need more help, resubmit your question with additional details and the full model number of your refrigerator (after rechecking it).

Read More
Lyle W -
Sears Technician