Model #HTV-C2 Pioneer components

  • Control Center
    3 Results

Question and Answers

Q:

Can you tell me where to find a reset button for the LED display on a generator model 580.325650?

A:

I am sending you an image of the led display on your generator. The reset is the button on the left of the monitor.

Read More
Jimmy K -
Sears Technician
Q:

Reset oil light

A:

Thank you for your question.

 

I will be happy to assist you. I looked up the model number you submitted. You are correct the manual does not show where the rest button is. I looked at the gauge and it looks like the reset button is just to the left of the display. With the engine running, push the button one time. This should clear the maintenance code. This will start the timer over again. The C1 indicates it is time to check the oil.

 

I hope this is helpful. Please let me know if you cannot find the button. If you could, please post a picture of the gauge.

 

Thank you for using Manage my life.

Mark

Read More
Mark T -
Sears Technician
December 04, 2013
Q:

Diagnostic info for Kenmore Elite 630.16303403 dishwasher

A:

Thank you for your question and I understand your concern.

Be sure the door is shutting properly or it will not power up. I added an image below with the information that you asked for. I hope this is helpful.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services.

 

Read More
Joey S -
Sears Technician
August 15, 2013
A:

Wolfgang: If there were no faults/fault codes, it would display "000" after the test. The foam being off would not make any difference. If the door switch is working correctly and based on your additional details, it very well could have a faulty control board. If the rinse aide is empty, it would also display "Refill Rinse Aid". If I were you, I would call a service tech and let him/her diagnose the failure. This way if the mis diagnose and install a part that does not resolve the issue, you will not be stuck with a part not needed.

Read More
Joey S -
Sears Technician
August 16, 2013
A:

Wolfgang; Looking at the image, the board will definitely need to be replaced.

Read More
Joey S -
Sears Technician
August 28, 2013
A:

Wolfgang: I glad I was able to help. You did a great job. Thank you for the reply and thank you for using Manage My Life.

Read More
Joey S -
Sears Technician
September 19, 2013
A:

Dan: Copy and paste the URL below in your browser and it will take to Manage My Life where you can view the diagram. http://www.managemylife.com/mmh/questions/356546-diagnostic-info-kenmore-elite-63016303403-dishwasher

Read More
Joey S -
Sears Technician
September 19, 2013
See more answers