Model #HO-84-2 Icp furnace/heater, oil

  • H-q Blower Assembly
    3 Results
  • Furnace Assembly
    3 Results
  • Oil Burner Assembly
    3 Results

Question and Answers

Q:

my wireing on my craftsman riding lawn mower

A:

Thank you for your question.

Wiring the whole tractor is quite the under taking. If wiring harness is not available, you do not have any other option than to make one. I will be happy to provide you with a diagram but I will need a model number. Please reply below with the model number and I will look it up for you.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
August 24, 2011
Q:

Is 56" the width of the 56 X 84 Ricardo Ultimate Black Out Curtain?

A:

The 56 designates the width in inches. The 84 designates the height. For a window that is 84" wide, you should need just 2 of the panels. You should not need extra length for gathering on a black out curtain. You can also use the 114" wide by 84" long curtain for the 84" wide window.

Read More
Lyle W -
Sears Technician
February 17, 2010
Q:

CRAFTMAN RIDING MOWER, MODEL: 917276760, ENGINE 18.5 ho ohv

A:

Thank you for your question.

I am sorry you are having a problem with the tractor. I believe that your problem may be a plugged gas cap vent or vapor lock. To check the cap run the tractor until it starts to run rough then loosen the cap, do not remove it, if the engine smoothes out the vent is most likely plugged and should be cleaned or the cap replaced. If the problem persists the try moving the fuel line away from the engine block. If you find the fuel cap is fine the problem might be a defective ignition coil. Once the coil heats up it stops producing the spark you the spark plug. Next time the engine dies check for spark at the spark plug.

Any parts you may need are available at Sears Parts Direct .

I hope this helps.

If I can be of further assistance please feel free to submit any questions you have along with the specifics.

Thanks for using Manage My Life.

Mark T.

Read More
Mark T -
Sears Technician
April 23, 2011