Model #HET-480C Modern Maid counter unit electric

  • (let-480) (aet-480a) (cet-480a) (het-480a) (ket-480a) (let-480a) (wet-480a) (aet-480b) (cet-480b) (het-480b) (let-480b) (ket-480b) (wet-480b) (aet-480c) (cet-480c) (het-480c) (let-480c) (ket-480c) (wet-480c)
    3 Results
  • (aet-480) (cet-480) (het-480) (ket-480) (wet-480)
    3 Results

Question and Answers

Q:

My Kenmore Elite HEt Washer won't start.

A:

Based on your symptom the door lock assembly has failed. The door lock assembly will need to be removed and replaced. Since I do not know your specific model number I added a link to Sears Parts Direct where you can look up and order parts.

I added an image below with the instructions.

Read More
Joey S -
Sears Technician
October 16, 2010
Q:

Why does my Kenmore elite HEt flash codes f/h and beep??? Do I need to call a service man or is it something we can manage to fix ourselves?

A:

The F/H code on your Kenmore Elite HEt washer indicates that you have a problem with the water fill components. The technical explanation of that code is shown in the image below. The link for a previous answer that Joseph P. posted in the above response also has information about that problem.

This type of failure is often a problem that you can diagnose and repair yourself. I recommend that you follow the troubleshooting shown in the image below. Check the water supply and fill hoses. Make sure that you have a hot and cold water supply properly provided to the washer. Check the drain hose installation for proper height to prevent siphoning of fill water. If the washer is filling properly and you are getting this code within about 30 seconds, then you likely have a bad flow meter.

Unplug the washer before accessing internal components. Most of the components involved in this failure can be accessed by removing the top panel of the washer. Screws at the very back of that top panel need to be removed and then you can pull the top panel slightly back then up and off of the washer. Check the wiring connections between the components and the CCU (Central Control Unit or main control board). If you need more replace parts, you can order them from the Sears PartsDirect website.

If you need more help with this failure, reply with additional detail and the full model number of your HE washer.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
August 06, 2011
Q:

Craftsman Weed Wacker, Model No. 316.796150

A:

Thank you for your question. I am sorry you are having a problem finding the correct information for the trimmer. I have done some research and found the instructions for replacing the trimmer line on your model. I posted the information in the image below. Click on the image to enlarge it. I got this information out of a manual I think is close to yours. Click here to load that manual. I hope this is helpful. Please let me know if you need further assistance.  Thank you for using Manage my life.Mark

Read More
Mark T -
Sears Technician
June 07, 2013