Model #HD-52Z575 Jvc projection/digital 42" and above tv

  • Cabinet Parts
    3 Results
  • Light Engine
    3 Results

Question and Answers

Q:

oil for lawn mower

A:

Thank you for the question.

Without a model number, I can only give you general information. Most 4 cycle lawn engines use SAE30 motor or. You should be fine using the HD30. If you have a model number, please reply below with it and I will make sure yours requires 30 weight oil.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
October 27, 2011
A:

The HD30 will be fine to use in the mower.

Read More
Mark T -
Sears Technician
October 29, 2011
See more answers
Q:

Frigidaire Gallery Series HD Dryer

A:

Thank you for your question and I understand your concern.

Based on your symptom and details, the noise is likely emitting from the rear drum bearing. It may need lubricated with some high temperature rated grease or the drum bearing could be worn down and the ball shaft could be rubbing the bearing support.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post along with the model number of your dryer.

Read More
Joey S -
Sears Technician
September 18, 2012
Q:

Manual HD Craftsman stapler #68447.

A:

Thank you for your question.

I am sorry you are having a problem with the stapler. If the staples are not feeding correctly, I recommend checking the staples first. This staple gun requires number 6 staples. If you are using a wide staple, they could be binding in the channel. If you are using the correct staple, look at the channel to see if it is bent. If the channel is bent, the staples will not feed forward. If you find it id bent try to spread the channel out to allow the staples to slide freely. If the above does not cure the problem could be a weak spring not pushing the staples forward. If this is the case, you can try to take the spring off the rod and stretch it out. If you decide to purchase a new staple gun here is a link to the one I have. As far as manual staple guns go this is the best one I have had. I used it to put in 9/16 inch staples and some times it would not set them all the way in. This is most likely because I was shooting into oak. On the ones that did not seat all the way in I tapped with a hammer.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage my life.

Read More
Mark T -
Sears Technician
January 10, 2013
A:

Thank you for your question.

I am sorry you are having a problem with the stapler. If the staples are not feeding correctly, I recommend checking the staples first. This staple gun requires number 6 staples. If you are using a wide staple, they could be binding in the channel. If you are using the correct staple, look at the channel to see if it is bent. If the channel is bent, the staples will not feed forward. If you find it id bent try to spread the channel out to allow the staples to slide freely. If the above does not cure the problem could be a weak spring not pushing the staples forward. If this is the case, you can try to take the spring off the rod and stretch it out. If you decide to purchase a new staple gun here is a link to the one I have. As far as manual staple guns go this is the best one I have had. I used it to put in 9/16 inch staples and some times it would not set them all the way in. This is most likely because I was shooting into oak. On the ones that did not seat all the way in I tapped with a hammer.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage my life.

Read More
Mark T -
Sears Technician
January 10, 2013
See more answers