Model #H50-65499R Tecumseh engine

  • Replacement Parts
    3 Results
  • Carburetor No. 632230
    3 Results
  • Rewind Starter No. 590420a
    3 Results

Question and Answers

Q:

I am installing a B&S Intek I/C engine and need to know how to connect the throttle linkage to the engine. Model# 12S432, type# 0036, code# F8.

A:

Thank you for your question on the change out of the engine.

I understand that you want to be able to control the speed of the engine from behind the handle bars.

However this is a standard replacement engine and has all the controls on the engine it self and I do not see any type of cable clamp holder on the side of the engine for installing a remote throttle cable.

I would suggest looking closely at the housing next to the throttle to see if there is a hole for a clamp to be screwed into for holding the throttle cable.

Also is there a hole in the throttle arm that would accept the hook on the end of the throttle cable.

It should have a choke lever and a gas valve cut off and a friction throttle control on the engine itself.

Please let me know what you see at that locations since I cannot get a picture that close to see if it has those holes

Sam A.

Read More
Sam A -
Sears Technician
May 04, 2012
A:

Thank you for the update. You may be able to use the same clamp and screw off the old engine if you still have it. Also you will have to loosen the friction damper for the throttle behind the panel, so your remote throttle cable will be able to move the throttle control. You may have to remove the cover to see the friction damper. Sam A.

Read More
Sam A -
Sears Technician
May 04, 2012
See more answers