Model #GV-6150 Go Video vcr

  • No Image Available - Wards
    3 Results

Question and Answers

Q:

Manco Go Kart Axle

A:

I don't have the length of that specific part. I have contacted the manufacturer to try and obtain that specification. I provided some general measurements for that go kart in the image below.

I will update this thread when the manufacturer responds regarding that axle length.

Read More
Lyle W -
Sears Technician
April 25, 2012
A:

The manufacturer indicates that they do not have the length specification on that axle since there is only one axle available for that go kart. It does not look like we will be able to help you with that specific measurement.

Read More
Lyle W -
Sears Technician
April 25, 2012
See more answers
Q:

washer GE lights on control panel are flashing

A:

Thank you for your question and I understand your concern.

Based on the symptom, it sounds like the washer is the service mode. All the LED's will flash when the unit is placed in the service mode.

Also, when you removed and replaced the control board, did you remove the "model select" harness plug jumper? You must remove the harness plug model selector jumper harness from the old control and install it on the new control or the control will not know which model washer and cycles it has and all the LED's will flash and the washer will not operate. If you did not remove the harness selector plug and installed it on the new control, this is why all the LED's are flashing. 
 
I added an image below of the tech sheet which should also should have come attached to the washer in the control panel or behind the front panel. I also added an image showing where the model harness plug connects.
 
I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

 

Read More
Joey S -
Sears Technician
November 13, 2013