Model #GSD2800G07 Ge dishwasher

  • Control Panel And Door
    3 Results
  • Tub Assembly
    3 Results
  • Motor-pump Assembly
    3 Results

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How to install the soap dispenser cover?

A:

NOTE :Disconnect power to the dishwasher before removing panel. The handle shaft must be inserted through the dispenser cover first, then the handle shaft will insert through the opening of the inner door panel. It will need to lock into the hub of the latch.

To remove detergent cup cover and handle shaft, push in fingers at end of shaft with a 1/4 inch socket.

To replace detergent cup handle shaft and cover, follow the steps below:

  1. Position latch spring on shaft hub as shown in Figure 27. Wind spring counterclockwise to hook end on installation pin.
  2. Position shaft and cup handle pointing up (cover open).
  3. Position latch on handle shaft as shown. Then press onto shaft until fingers snap in place.
  4. Turn latch counterclockwise to position end of spring onto tang.

I recommend calling a service technician to install your new dispenser cover.

Read More
Joey S -
Sears Technician
April 08, 2008