Model #GHW9150PW1 Whirlpool residential washers

  • Top And Cabinet Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Dispenser Parts
    3 Results
  • Tub And Basket Parts
    3 Results
  • Pump And Motor Parts, Optional Parts (not Included)
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

What does "F11" fault code indicate on my Duet washer?

A:

F11 is an indication of a communications problem.

Communications cannot be sent correctly between the machine control board and the motor control board.

Here are some possible causes:

  • Loose wire connection at either the machine control board or motor control board.
  • Machine control board failure
  • Motor control board failure
  • Door lock
  • Motor

I recommend calling a technician to come and properly diagnose the failure.

Read More
Joey S -
Sears Technician
July 11, 2008
Q:

Why won’t my washer turn on?

A:

This is a very labor intensive do it yourself project, I highly recommend calling a service professional to diagnose and repair your appliance. I assume the unit is completely dead and will not light up. First you will need to find out how the user interface got wet, i.e. leaking hoses, or a bad inlet valve. This will need to be fixed so that the user interface will no longer become wet. You will then need to make some voltage checks. If you have a volt/ohm meter and are comfortable working around live electricity I can give you a few checks that will help you diagnose the problem. Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts. Working with live electrical current can be very hazardous and possibly deadly. Testing voltage output requires working with electrical current. Do not attempt this measurement without the proper tools and safeguards. (See images below)

  • Begin by locating IF2 on the CCU (Central Control Unit), check voltage across these 2 points on the CCU.
    • You should have 120 VAC (Voltage Alternating Current). If you have 120 the user interface will need to be replaced.
    • If not check VAC at the outlet, no voltage, check the breaker. Then you will need to check the line filter. If you have VAC at the outlet, and no voltage at the line filter, the cord is bad. If you have voltage to the line filter and 0 VAC to the CCU the line filter will need to be replaced.

If you require further assistance please resubmit question with details of the checks you have made. I will be looking forward to helping you again in the near future.

Read More
Landell -
Sears Technician
February 02, 2010