Model #GBD307PRS01 Whirlpool built-in oven, electric

  • Lower Oven Parts
    3 Results
  • Upper Oven Parts
    3 Results
  • Oven Door Parts
    3 Results
  • Latch Parts
    3 Results
  • Internal Oven Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Top Venting Parts, Optional Parts
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Whirlpool Double Oven Repair

A:

Check the house circuit breaker or fuses for the oven. If the breaker is tripped, the oven control board will not get any power.

If the breaker is okay, visibly check the bake and broil elements for damage. If one of those elements is broken and shorted to the metal inside the oven cavity, then this could have blown the thermal fuse for the control board. That fuse is circled on the wiring diagram below. A failure of the cooling fan for that control could also cause the thermal fuse for the control board to blow. You can shut off the house circuit breaker for the oven and pull it out of the cabinet then remove the top panel over the control to check the thermal fuse for the control board. Here is a link for that video that shows how to check that thermal fuse using a volt/ohm meter: Thermal Fuse Testing . If that thermal fuse is blown, then it will need to be replaced. You will also need to check the cooling fan and other components to determine the cause of that failure.

You can order parts from the Sears PartsDirect website.

If the thermal fuse is okay, you could have a bad transformer or a failed control board. You could also have a wiring failure or a voltage supply problem. Reply with additional details if you need more help with this failure.

This can be a difficult failure to diagnose and repair on your own. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
October 27, 2011
Q:

Replaced Control Panel on Double Oven

A:

Thank you for your question and I understand your concern.

I must assume you did not program the oven cavity size after installing the oven control. The new control must be programmed for the oven cavity size of your oven before it can be used. The instructions for programming the oven cavity size should have been supplied with the new oven control.

Use 30 as the oven size and follow the instructions I provided in the image below if the new control did not come with the instructions.

This may be the issue. If not, please reply and I will be glad to assist you further.

Read More
Joey S -
Sears Technician
July 05, 2012

Recommended maintenance parts & accessories

Show 3 more
No more item to show