Model #FTF2140FS1 Frigidaire residential washers

  • Control Panel
    3 Results
  • Cabinet/top
    3 Results
  • Motor/tub
    3 Results
  • Wiring Diagram
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I have a Frigidaire Front Load Washer Model#FTF2140FS1, Serial #XC81818846 where I'm having to replace the Door Latch part #131763202 and I was

A:

Thank you for your question and I understand your concern. I added an image below with the instructions. NOTE: Disconnect the power cord from the power source before accessing and replacing the door lock assembly.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
January 20, 2011
Q:

Front load washer door switch replacement & how to drain drum

A:

The easiest way to drain the washer is to put the washer into a drain and spin cycle. The washer will not spin but is should pump the water out. I have provided you with the instructions for replacing the door lock below. The door lock is accessed by removing the door boot. Make sure to unplug the washer before attempting to replace the door lock.

You can also run just the drain pump in the diagnostic cycle. The instructions are in the tech sheet you used to fine the code. I would be happy to provide you with more assistance if you run into problems. Please submit the question below.

Thank you for using Manage my life.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Mark T -
Sears Technician
September 13, 2010
Q:

Frigidaire Washer Error Codes & Spinning

A:

Thank you for your question and I understand your concern.

Based on your symptom and details I recommend replacing the door lock assembly and it will most likely go into the high speed spin again.

Removing and replacing the door lock assembly is a DYI procedure. To access and replace the door lock assembly you will need to first disconnect the power cord. The wire and spring securing the boot will need to be removed. You will need to pry the wire up out of the channel. Be sure to place the spring at the bottom center before rolling the wire retainer on. The boot will need to be peeled back next to the door lock in order to remove and reinstall the door lock assembly. I added an image below with the procedure.

The part number of the door lock for your Frigidaire front loading washer model FTF2140FS1 is 131763202 which can be ordered from Sears Parts Direct.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
March 15, 2012

Recommended maintenance parts & accessories

Show 3 more
No more item to show