Model #FH-10 Muskin swimming pool accessories

  • Replacement Parts
    3 Results

Question and Answers

Q:

What does FH error code mean on my washer?

A:

Click on the link below for the answer to your question.

What does the FH error code mean on my Kenmore washer?

Read More
Joey S -
Sears Technician
July 23, 2008
Q:

What does FH error code indicate?

A:

There is nothing wrong with your washer. Your washer has an ATC (Automatic Temperature Control). The ATC electronically senses and maintains a uniform water temperature. The ATC regulates incoming Hot and Cold wash water. The ATC is automatically turned ON when a cycle is selected. In wash water temperatures colder than 70 degrees detergents do not dissolve well. Soils my be difficult to remove. The cold rinse temperatures depend on the cold water at your faucets. Cold wash fill temperatures will be regulated.

The HOT water must remain on to regulate the Cold water temperature or "FH" error code will display. NOTE: Not all Modifiers are available with all cycles and options.

When the HOT water is shut off, the washer will display "FH" because it does not see any HOT water flow when it calls for HOT water. IF you leave the HOT water ON the washer will not display "FH" error code and it will operate as designed.

The Auto Temp Control ATC (Auto Temp Control) electronically senses and maintains a uniform water temperature. ATC regulates incoming hot and cold water. The ATC is automatically turned ON when a cycle is selected.

  • ATC ensures consistent cleaning.
  • ATC works for the wash temperature with Extra Hot/Cold, Hot/Cold, Warm/Warm, Warm/Cold, and Cold/Cold settings.
  • The Cold rinse temperatures depend on the cold water at the tap.
  • For the Tap Cold/Cold setting, both wash and rinse temperatures depend on the cold water at the tap.
  • The Warm rinse setting regulates the water temperature at approximately 104°F (40°C).

The HOT water must remain on to regulate the Cold water temperature. NOTE: Not all Modifiers are available with all cycles and options.

When the HOT water is shut off, the washer will display "FH" because it does not see any HOT water flow when it calls for HOT water. IF you leave the HOT water ON the washer will not display "FH" error code and it will operate as designed.

Read More
Joey S -
Sears Technician
October 14, 2008
Q:

why am I getting error code fh?

A:

I added a link below with an answer from a previous question that should assist you dianosing the failure code "FH". If after 30 seconds the control does not detect water entering machine, the valves will be turned off and the error code will be displayed. OR If the control has turned the water valves on and after 8 minutes the flow sensor has detected 10.5 gallons of water passing through it, but has not detected the pressure switch trip, the valves will be turned off and the error code will flash. Press PAUSE/CANCEL twice to clear the display.

Which Valve and should I replace for the "FH" code?

Read More
Joey S -
Sears Technician
September 14, 2010