Model #FEF352AWG Frigidaire free standing, electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results

Question and Answers

Q:

What would cause my range to not heat up I replaced the bake element?

A:

If the surface elements operate but neither heating element (bake or broil) operates the likely failure is the electronic oven control board or a burnt wire connection. I added the wiring diagram in the image below. If it's not a control board failure it could have a burnt wire connection on line two (L2) voltage supply coming IN or going OUT of the control board.

I recommend calling a service technician to diagnose and repair your range.

Read More
Joey S -
Sears Technician
March 18, 2009
Q:

where does the foil tape go on my oven door

A:

The foil tape fits up in the upper two corners and one piece across the two as shown in the image below. See key numbers 14 and 14A. The foil should fit in the same places as the original foil.

Read More
Joey S -
Sears Technician
May 20, 2010
Q:

my oven has stopped working. Just the oven the top works fine. The clock has also went out on the unit. Is it hard to replace the part?

A:

Thank you for your question.

Not having your oven working is very inconvenient.

  • It is not that difficult and I think that if you have some mechanical ability,you can do this with some instruction. You will need some basic tools. A Phillips screw driver a 1/4 nut driver.

  • First REMOVE POWER to the range by flipping the circuit breaker for the range off or unplug from the electric receptacle behind the range.

  • Pull the range out from the wall so you can access the rear upper back cover. Locate and remove the screws that secures the top cover to the range.

  • Locate the Oven Range control panel in the console and remove the 4 screws that holds it to the console.

Note! The key pad may come out with the control and may have to be separated from the control to be put on the new control.

  • With the new Control in your han replace wire connection plugs one at a time.

  • Install the new control and position the key pad in front of the control in the control panel,and re-install the screws that holds the oven control to the control panel.

  • Re-install the back panel and test operation.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
October 05, 2010

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show