Model #EV-C20 Sanyo vcr

  • No Image Available - Wards
    3 Results

Question and Answers

Q:

I want to know how to change the kit-pulley (545050408) for the Craftsman 32cc 2-cycle Gas brushwhacker model No. 358.795822 or why is my line not retracting ev

A:

The starter pulley and spring might have debris in them. It is possible the pulley is worn. You need to take the trimmer apart and inspect the starter pulley, spring, and spacer.

Remove the trigger housing on the drive shaft by removing the 4 screws and separating the housing. Make note of how the trigger and the throttle cable mount in the housing.

To remove the clutch drum, remove the small torx head bolt in the center of the drum. The clutch drum will slide off the engine shaft. If the engine shaft turns when you are removing the screw, remove the spark plug and fill the cylinder with small clean rope. The rope will jam the piston and stop the engine from turning.

Remove the screws holding the fan housing to the engine and remove the fan housing. The rope and the starter pulley are inside the fan housing.

Be very careful removing the starter pulley and spring. The spring will unwind violently if it is released.

As you install the rope on the pulley, turn the pulley. Let the turning of the pulley wind the rope and it will load the spring so it will retract.

Read More
Jimmy K -
Sears Technician
July 02, 2010
Q:

Soft Water Systems, U.V. Disinfection - Salt Level Issues

A:

The technician may have tested the water with the system bypassed to get accurate measurements of the original hardness and other water conditions. A hardness test can normally be performed by the technician at the home. The technician probably checked that. I recommend that you call the technician to see if he tested the house water without bypassing the system. He may be able to give you the results of that test.

If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
February 04, 2013