Model #E225 (SELF RETURNING CYLINDER) Weider misc exercise

  • Frame & Backrest Assemblies
    3 Results
  • Bracket & Stepper Assembly
    3 Results
  • Peck-deck Arm Attachment & Leg Curl Assemblies
    3 Results
  • Stepper Handle & Leg Press Bar Assemblies
    3 Results
  • Flex Band Attachment & Arm Press Handlebar
    3 Results

Question and Answers

Q:

Cylinder head

A:

Thank you for your question.

I am sorry you are having a problem with the snow blower. The best thing to do in this situation is to replace the cylinder head. The part number for the head is 36449. We no longer offer this part but I did find it on line. Click here to be taken to the site that has them. You also need a head gasket. The part number for the gasket is 36451. The part can be ordered from the following link. Craftsman snow blower parts

I hope to hear from you.



Mark

Read More
Mark T -
Sears Technician
November 13, 2012
Q:

Throttle control on LT3000 not returning

A:

Thank you for your question.

I am sorry you are having a problem with the tractor. The choke on the carburetor is spring loaded. If it is not opening when you lower the throttle, I recommend checking the linkage for binding. If it is not binding I suspect the return spring on the choke is the problem. The image below shows how the linkage should be connected and how the choke spring should be installed.

As for the engine stalling when you put the tractor into gear. usually this is because of the seat switch. Your Tractor uses an Operator Presence (seat) switch that will cause engine to stall if blades are engaged or the brake is released without anyone on the seat. If ample amount of weight is not kept on the seat during operation or the operator is leaning forward the tractor will stall because the Operator Presence (seat) switch senses that the operator is not completely on the seat.

To check Operator Presence (seat) switch:

  1. Lift seat.
  2. Locate wires that connect to Operator Presence (seat) switch under the seat.
  3. Disconnect and clean any debris in the switch connector. Use an ohmmeter to check the switch. When the switch is not pushed, the reading should be 0 ohms (closed). When pushed it should read ol ( open load )
  4. Make sure the connector is fully seated on the seat switch. The connector is a special connector that will short the two wires if it is not fully seated.

I hope this is helpful.

Please click on the following link to order the parts you need. Sears Parts Direct

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Please let me know if you need further assistance.

Thank you for using Mange my life.

Mark T.

Read More
Mark T -
Sears Technician
August 17, 2011
Q:

Torque specs for head cylinder?

A:

If the head gasket of the engine is blown, you have to install a new gasket. The head gasket should not be reused. I recommend cleaning the old gasket off with carburetor cleaner and a scotch bright pad. You can use a razor blade if you are careful not to scratch the gasket surface. Do not use any kind of sealer on the new gasket. I have provided you with a chart below that have the pattern you need to tighten the bolt. The head bolts should be torque to 140 inch pounds. The part number for the head gasket is 692249 and can be ordered from the following link. Head gasket

Replacing the head gasket should be a fairly simple repair. Please feel free to submit more details if you need further assistance.

Thank you for using Manage my life.

Here is a link to order any parts you need. Sears Parts Direct .

Read More
Mark T -
Sears Technician
August 14, 2010