Model #DF-1200-1 Empire furnace/heater, gas

  • Functional Replacement Parts
    3 Results

Question and Answers

Q:

Dryer turning off, code df. What to do?

A:

Thank you for your question and I understand your concern.

Having the model number of your dryer would help in providing a better answer. I can't be 100 percent sure what the "df" means but if the dryer will not start it likely has something to do with the door switch. (Door Failure)

Reply with the model number and re-verify the fault code if you feel confident in repairing this problem yourself.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
June 08, 2011
Q:

whispertone 1200 power will shut off when pulling back

A:

Thank you for your question.

With out the model number I will only be able to give you general information and general area's to check for this issue.

The problem is in the connections where the handle and or upper and lower tubes plug into the Power Mate.

• Check to make sure that all the connectors are locked.

• To isolate the troubled connection, with the vacuum on use one hand to hold the upper wand and try to pull with the other hand to see if it is the connection where the handle plugs into the wands. If that checks ok, the put one foot on the power mate and pull up. If in either case the power mate stops it will be either the upper or lower connection.

• The most likely is the where it plugs into the lower connection on the power mate.

• Examine the two prong plug connection for arcing (black discoloration) or any melting around the connection.

• If you discover that is the problem the lower wand and the wire plug on the power mate will have to be replaced.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
September 01, 2010
Q:

I have a Craftsman Digital torque wrench that I need instructions on how to re-calibrate the torque wrench.

A:

Thank you for your question on the Digital torque wrench re-calibration. The torque wrenches have to be sent to a re-calibration center location in Garland Texas.

Kingsley Tools, Inc 3000 W Kingsley Road Garland, TX 75041-2313 Phone :( 972) 271-7117

If you will send them your torque wrench they will calibrate you 3/8 digital torque wrench.

You may want to call them first to get the cost of the calibration and shipping costs.

I have seen some web-sites about doing your own re-calibration but I do not know how accurate that can be.

I hope this information will help.

Sam A.

Read More
Sam A -
Sears Technician
February 29, 2012