Model #DEVILLE 410(5AKG) Smith Corona typewriter

  • Base
    3 Results
  • Deck
    3 Results
  • Flex Circuit
    3 Results
  • Keyboard
    3 Results
  • Key Board Reference Chart -5aei,5aci,5awi,5aba,5akg,5api,5adh
    3 Results
  • Keyboard Reference Chart For 5aeg,5acg,5awg,5adf,5ash,5akf,5aeh,5ach,5awh,5aph,5adg,5asi,5ahb,5akh,5apg,5ana
    3 Results
  • Carrier Molding, Rails And Frames
    3 Results
  • Carrier Drive
    3 Results
  • Element Drive
    3 Results
  • Ribbon Drive
    3 Results
  • Ribbon And Correction Cassette
    3 Results
  • Hammer
    3 Results
  • Paper Feed
    3 Results
  • Transformers
    3 Results
  • Control Pc Board
    3 Results
  • Control Pc Board For 5aeg,5acg,5adf,5awg,5ash,5ana,5ach,5aph,5adg,5ahb,5akh,5aeh,5awh,6apg,5asi,5akf
    3 Results
  • Diagram
    3 Results
  • Diagram
    3 Results
  • Diagram
    3 Results
  • Diagram
    3 Results
  • Diagram
    3 Results
  • Diagram
    3 Results
  • Diagram
    3 Results

Question and Answers

Q:

How do I get a receipt on a pressure washer purchased a few years back?

A:

You will have to go to a Sears retail store personally. Take some form of identification and if possible the owners manual for the pressure washer.

You might need to speak to the department manager for division 09. Sears is very careful about giving customers information out. The people at the retail store should be able to pull up the information on the pressure washer and print you out a copy.

Read More
Jimmy K -
Sears Technician
February 24, 2009
Q:

Kenmore Range Model Number: 362.75507000

A:

The image below shows how to adjust the factory temperature setting on this range up to 35 degrees. I recommend that you check the oven temperature compared to the set temperature after the oven heats up and cycles on and off at least 5 times at operating temperature. Take an average temperature over a 10 minute period to determine the actual oven temperature. Make sure that you are using an accurate thermometer. Based on that temperature, you can use the procedure shown below to adjust the control for an offset. This should help you with that problem.

The oven may not be preheated to the exact operating temperature when the control indicates that it is preheated. That is why I recommend that you use the procedure described above and shown in the image below. If the operating temperature is accurate, I do not recommend that you replace any components or adjust the range. Give the range a little longer to preheat if necessary. In some situations, the range may take slightly longer to preheat.

If the operating temperature is more than 35 degrees off when measured properly, then you may need to replace the oven temperature sensor or the clock control board. Reply with additional details if you need more help.

If you get to a point where you want to have a service technician examine the range, then you can schedule one through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
December 21, 2011
Q:

Dishwasher not running. Pushing any buttons on the panel activates the "lock on" button.

A:

Thank you for your question and I understand your concern.

 

If the control detects that a key is stuck in the depressed position, dishwasher operation will be suspended and the control will flash the light for that key until the condition is corrected. If a key without a light is stuck or multiple keys are stuck, the control will flash the Lock-Out light.

Based on your symptom and details, the control panel assembly will need to be replaced. It appears that black is the only color available for the control panel/console for model 665.15979992 at Searspartsdirect. Based on the cost of the control/console assembly, you may want to consider replacing the dishwasher rather than repairing it. 

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

 

Read More
Joey S -
Sears Technician
May 22, 2013