Model #CST1000 TYPE 5 Black & Decker hedge trimmer, electric

  • Trimmer Assy
    3 Results

Question and Answers

Q:

What is the operating RPM of a Craftsman 103-2179 12" jig saw with 5" pin type blade?

A:

If you are needing the rpm of the input pulley it should be around 1000-1200.

Read More
Jimmy K -
Sears Technician
September 22, 2008
Q:

Briggs&Stratton 5 HP, model 135212, Type 0140 01

A:

Thank you for your question.

I have checked the model number you have submitted. Your engine does not have points. I recommend checking the air gap setting first. It should be set at 0.012 if it is off there will not be any spark. Once the air gap is set, remove the kill wire and check for spark. If there is spark reconnect the kill wire and check again. If there is no spark, the kill circuit is shorted. If you never get spark the magneto defective. There is a sight possibility the magnet on the flywheel has lost its magnetism but it is not likely. I hope this is helpful.

Here is a link to order any parts you need. Sears Parts Direct .

Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
January 24, 2011
Q:

How do I connect a new stop cable to my SCOTTS push mower. The old stop cable had a S or 5 type connector that broke off, where on the engine do I re- connect.

A:

That type of mower typically has a Briggs & Stratton engine. You should see a bracket that holds the cable in place on the engine as shown in the image below. That cable connector should fit into the engine control lever that is just in front of that bracket.

 

If you have a different type of engine on that Scotts push mower, reply with additional information and the full model number of the mower and/or engine. 

Read More
Lyle W -
Sears Technician
May 02, 2013