Model #CP-111 DEMOLITION TOOL Chicago Pneumatic impact tool

  • Unit Parts
    3 Results
  • Air Swivel Assembly
    3 Results
  • Backhead Assembly
    3 Results
  • Revision Of Backhead Assembly
    3 Results
  • Cylinder Assembly
    3 Results
  • Hardware
    3 Results

Question and Answers

Q:

What tool

A:

Thank you for your question.

I am sorry you are having a problem removing the bolts that secure the belt guard. I know the outside hex is 3/8 and I believe the inside is a size 25 torx. If you have a 1/4 inch drive 3/8 socket you should be able to get onto one of the bolts and remove it. Then take that bolt to your local Sears store and match up the torx. Before using the torx to remove the screw, use a pick or something small to clean out the debris in the recess of the bolt. This will prevent damage to the bolt head.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage my life. Mark

Read More
Mark T -
Sears Technician
September 12, 2012
A:

Anonymous,

Thank you for posting the size of the torx bit needed to remove the bolts. I am sure other users will find it useful.

Please let me know if you need further assistance.

Thank you for using Manage My Life! Mark T.

Read More
Mark T -
Sears Technician
September 17, 2012
See more answers
Q:

can i use my washing machine with GFI outlet? model 2294103 cp 3203164

A:

Thank you for your question and I understand your concern.

I added a link below with an answer to your first question.

Can I use a ground interrupt outlet on my washer?

Read More
Joey S -
Sears Technician
August 31, 2011
Q:

Kenmore wacher unit style 111.

A:

Thank you for your question and I understand your concern.

Without having the model number of your washer I can only provide general information.

Your correct in thinking the lid is not striking the lid switch.

The lid switch is likely broken or the lid is not shutting properly and striking and closing the lid switch. On some models the hinge strikes the lid switch and on some models there is a lid strike located on the bottom edge of the lid which will protrude through a small opening in the top and strike the lid switch or lid switch actuator.

So that's what I can tell you at this point. I can give you more detailed help if you could provide me with the complete model number. The model numbers are typically located near the tub opening after opening the lid. If you could supply me with that information and add it to the thread I will be happy to assist you further.

Read More
Joey S -
Sears Technician
September 09, 2011