Model #CORRECTION-1 Sanyo direct view\digital 27" to 40" tv

  • No Image Available - Wards
    3 Results

Question and Answers

Q:

Correction on Model #

A:

On that refrigerator model, the compressor is rated at 150 watts, the condenser fan is rated at 13 watts and the evaporator fan is rated at 10 watts. The refrigerator will use about 180 watts of power when the compressor is running. In the defrost mode, the 450 watt defrost heater will be energized for about 25 minutes. This defrost mode will occur after 8 hours of cumulative compressor run time.

This information should help you. Be aware that you will need to be prepared for an instantaneous spike in the amp draw during the start-up of the compressor in this refrigerator.

If you need more assistance, reply with additional details.

Read More
Lyle W -
Sears Technician
September 06, 2011
Q:

This as a correction on my last message.

A:

Thank you for your question. I am sorry you are having a problem with the snow blower. If the impeller shaft is turning but the auger shaft is not I suspect the worm gear in the gearbox is sheared. The cost of the worm gear is less than the complete assembly but the repair is a little bit more involved. The part number for the gear is 917-0528A and can be ordered from the following link.  http://www.searspartsdirect.com/partsdirect/part-number/917-0528A/0071/247?pathTaken=directMatch&filterPart=&pop=flush&prst=0&shdPart=917-0528A. Once you have the gearbox removed, you need to separate the two halves. Then clean out all the grease and pieces of the broken gear. Finally install the new gear and fill with new grease. The image below shows the basic steps for doing this repair. Just click on the image to enlarge it. If you cannot see the image, please copy and paste the following address in your browser. http://www.searspartsdirect.com/partsdirect/part-number/917-0528A/0071/247?pathTaken=directMatch&filterPart=&pop=flush&prst=0&shdPart=917-0528A I hope this is helpful. Please let me know if you need further assistance.  Thank you for using Manage my life. Mark

Read More
Mark T -
Sears Technician
March 21, 2013
Q:

Trying to determine correction position of link

A:

Thank you for your question.

I am sorry you are having a problem with the trimmer. I will be able to help you with the repair. I have pasted an image below showing how the linkage is connected. It looks like you have tried to make replacement rods for the linkage and the spring has been stretched. These two parts are what is used to speed the engine. I recommend ordering a new spring and rod. You can order the replacement parts from our parts website: Sears Parts Direct .

I hope this is helpful. If you need further assistance, please rely below with more details and a model number.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
May 25, 2011