Model #CHIPPEWA3.5HP-5HP Ww Grinder chipper shredder/vacuum, gas

  • Main Frame
    3 Results
  • Cylinder Assembly
    3 Results
  • Centrifugal Clutch 3/4" & 1" Bore
    3 Results

Question and Answers

Q:

Gamefisher 5HP model 217586613

A:

Thank you for your question.

I can understand wanting a new o-ring for the fuel connector on the outboard motor.

I am sorry but they do not list the size of the o-ring for the motor.

I can get you a part number for the fuel fitting but not just the o-ring.

I would suggest taking the motor to a Marine service shop in your area and ask the service parts counter person if they would have and 0-ring that would fit that engine. They may be familiar with replacing these and have them in stock. They may also have a universal o-ring kit that they can pick from.

Your local big box home centers will have and o-ring drawer to choose from as well and some auto-parts stores in the area.

I apologize that I could not get you that information for you.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
May 24, 2011
A:

Thank you for the update. Now I know this and will record this in our archives. Again that you so much for replying. Sam A.

Read More
Sam A -
Sears Technician
May 25, 2011
See more answers
Q:

5hp gas leaf blower

A:

Thank you for your question.

 

I know how important it is to have the manual for your products. I searched for a manual for your leaf blower. I am sorry the manual is not available for this unit. If you are having a particular problem with the blower please reply below with the details. I will be happy to assist you with it.

 

Thank you for using Manage my life.

 

Mark

Read More
Mark T -
Sears Technician
October 04, 2013
A:

If you can start the engine with starting fluid, I suspect the main jet is partly plugged or the carburetor needs to be cleaned. I recommend trying to clean the main jet first. I found a video that shows how to clean the main jet on an engine similar to yours. Click on the following link to watch the video. http://www.youtube.com/watch?v=HjzasttXpMU How to clean a main jet Be sure to work in a well ventilated area without any open flames. Please let me know how this works. Thank you Mark

Read More
Mark T -
Sears Technician
October 09, 2013
See more answers
Q:

Craftsman model 917.295460 5HP tiller

A:

Thank you for your question.

I will be happy to assist you with the tiller. I have looked up the manual for model 917.295450. The information in that manual will be accurate for your model. To change the oil start the engine and let it run for 5 minutes to warm the oil. Then remove the oil drain plug and the oil fill plug. After the oil is drained, reinstall the drain plug and refill with SAE30 motor oil.

The engine uses regular unleaded gas.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark

Read More
Mark T -
Sears Technician
April 06, 2012
A:

Erica, As long as the engine is full and the oil looks ok, I recommend starting it. You only want to let it run long enough for the oil to warm up. This will allow the oil to drain faster and it suspends any debris in the oil. If you drain the oil without starting the engine, the gunk that has settled to the bottom of the engine will not get flushed out. Please let me know if you need further assistance.

Read More
Mark T -
Sears Technician
April 09, 2012
See more answers