Model #CGP350SET1SS Ge counter unit, gas

  • Control Panel & Cooktop
    3 Results
  • Gas & Burner Parts
    3 Results

Question and Answers

Q:

cooktop burner knob not igniting

A:

Thank you for your question and I understand your concern.

By the time you get this response, your cooktop burner will most likely be operating correctly again.

When the water was spilled, it most likely affected the two switches mounted on top of the burner valve controlling that specific burner. One switch is for the spark ignition and the other turns on the back lighting LED's. Once the water evaporates and the two switches dry out; it will likely work properly again. I don't think you will need to replace any parts. Once the switches dries out; it will likely operate normally again.

I added two images below of the technical sheet for further reference if needed. The information in the images will provide the instructions for accessing the switches on the gas valves. NOTE: If you do have to take it apart to dry out the switches; be sure and disconnect the power cord from the power source before servicing.

This may be the issue. If not, please reply and I will be glad to assist you further.


Read More
Joey S -
Sears Technician
September 13, 2013
A:

Anonymous: If gas flows when the knob it rotated, the knob is ok and the problem would have to be with the two switches mounted on the that specific burner valve. Follow the instructions in the images I provided in my first response and remove the top and inspect the two switches on the burner valve. NOTE: Disconnect the power cord from the power source before servicing. The two switches can be tested with an Ohm meter. In the off position, the two switches should not measure any continuity across the terminals. Be sure and disconnect the wires from the switches before testing the switch operation.

Read More
Joey S -
Sears Technician
September 16, 2013
See more answers

Recommended maintenance parts & accessories

Show 3 more
No more item to show