Model #BR-1 Allegheny misc exercise

  • Unit Parts
    3 Results

Question and Answers

Q:

Household gas pressure/gas stove

A:

Thank you for your question and I understand your concern.

Based on your symptom and details it sounds like it may have a faulty gas pressure regulator on the range or the gas supply line connected to the range is not adequate in order to provide the pressure.

The inlet pressure to the regulator should be as follows for proper operation:

Natural Gas:

  • Minimum pressure: 5" WCP
  • Maximum pressure: 14" WCP

LP Gas:

  • Minimum pressure: 11" WCP
  • Maximum pressure: 14" WCP

Contact local gas supplier if you are not sure about the inlet pressure.

So that's what I can tell you at this point. I can give you more detailed help if you could provide me with the complete model number. The model numbers are typically located around the oven cavity opening. If you could supply me with that information I will be happy to assist you further.

Read More
Joey S -
Sears Technician
April 20, 2012
A:

The Pinion: Let me know what they find. I suspect a faulty pressure regulator at the range or at the supply.

Read More
Joey S -
Sears Technician
April 24, 2012
See more answers
Q:

The "BR" plug and the "L1" plug are in opposite spots from the old timer. What do I need to do?

A:

The location of "BR" and the "L1" should not matter. Just make sure to connect the "BR" harness plug to the "Broil" (BR) on the "BR" connector terminals and connect the "L1" wire harness plug to the connectors marked "L1" on the ERC and you should be OK.

Read More
Joey S -
Sears Technician
October 12, 2009
Q:

Whats the bolt torgue spec. for my craftsman 4.25 hp / 172 cc cylinder head cover-part # 37714 /gasket assembly part # 37715.

A:

Thank you for your question. I am sorry you are having a problem with the engine. I posted a few images below. The first image has the torque sequence and the second has the torque specs. Just click on the images to enlarge them. Look at the first image and find the one that matches yours. Then take the engine number that is posted by the head image and use it to find the torque spec on the second image.  Please let me know if you need further assistance.  Thank you for using Manage my life. Mark T.  

Read More
Mark T -
Sears Technician
March 18, 2013