Model #BLAZE Bowflex weight system

  • Seat/rear Leg Base
    3 Results
  • Bar/backbone Assembly
    3 Results
  • Lower Lat Tower/base Frame
    3 Results

Question and Answers

Q:

my mower is starting up but the blaze will not turn.

A:

 

Thank you for your question and I understand your concern.

Without having the model number of your mower I will not be able to provide any model specific troubleshooting assistance. If it has an electric clutch, the clutch could be bad, it could have a seized mandrel or the belt is not tightening up when the blade engagement lever is engaged. If your model does not have an electric clutch for the blades, when you engage the lever to start the blades, the bell crank and pulley must pivot in order to tighten the belt in order for the blades to turn.

Sometimes the bell crank will not pivot enough due to debris or it may need lubricating where it pivots on top of the mower deck.

So that’s what I can tell you at this point. I can give you more detailed help if you could provide me with the complete model number. If you could supply me with that information I will be happy to assist you further


 

Read More
Joey S -
Sears Technician
May 14, 2013
Q:

"PIVOTRIM" adaptation for WEEDWACKER

A:

Thank you for your question and I understand your concern.

The head should screw on and off the output shaft of the gear box. Rotate the cutting head assembly counter clockwise (CCW) to unscrew the head. To prevent the gear box from turning there is a notch right where the base of the head assembly. You can put a screwdriver down into that notch to keep the gear box from turning when you unscrew the head assembly. If there is not a notch near the base of the head, check around on the gear box for a button that pushes to lock the gear box up.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
September 06, 2013
A:

Ralph: I'm so sorry. I'm glad you were able to get off.

Read More
Joey S -
Sears Technician
September 13, 2013
See more answers