Model #BC-1522 Haier air conditioner -room

  • No Repair Available
    3 Results

Question and Answers

Q:

kenmore washer/dryer 713gt/bc has no power?

A:

Hi Chris,

Thank you for submitting a question to Manage My Life.

I am sorry you are having problems with your laundry products.

I was not able to find any information using the numbers you gave.

The model number for this product should be located just inside the door or on the back panel. If you are able to locate the model number and give me a few more details I will be happy to assist you in any way I can.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thanks again for using Manage My Life.

Landell

Read More
Landell -
Sears Technician
June 06, 2011
Q:

My treadmill circuit breaker trips after 15-22 minutes of use. Do I just need a motor replacement?

A:

If the motor is not making a noise or sparking, it is probably ok. It is normal for the motor to get too hot to hold your hand on it.

The circuit breaker may be weak. Circuit breakers get weak if they are failing.

If the walking belt is worn or needs lubrication, it will cause the motor to draw more amps and heat more than normal.

Lift the walking belt on each side and look at the walking board. Check for wear on the walking board and belt by running your hand across both. If you feel any roughness or worn spots, that part needs replacing.

To test the walking belt lubrication, do not turn the treadmill motor on. Set the elevation to the highest level. Stand near the front of the walking belt. Push yourself firmly toward the rear of the treadmill. If the belt is properly lubricated the belt will take you to the rear edge of the treadmill and dump you off on the floor. If you move and stop, the belt needs lubricating.

The part number for the belt lubrication kit is 219168. You can buy it at [www.searspartsdirect.com]. The cost is around $4.00. The application instructions should be in the package, but in case they are not here is how to apply the lubrication.

Turn the walking belt until the belt seam is along the top of the front roller. Raise the belt on one side in the center of the walking board front to back as high as you can. Apply ½ the tube of lubrication to the walking board in a zig zag fashion moving from front to back. Move the belt until the seam comes up on top of the rear roller and lift the belt again and put the rest of the lubrication on the walking board in the same manner. Turn the treadmill on and walk on the belt for 10-20 minutes. Walk all over the belt to distribute the lubrication evenly on the walking belt and board.

Read More
Jimmy K -
Sears Technician
February 18, 2010
Q:

Hi. I have a Samsung dryer model # DV219AEW/XAA I bought a belt for it bc the belt was shredded and I put it on but it will only spin slowly now. Any help?

A:

The part number for the belt on that model of Samsung dryer should be 6602-001655. If you received the wrong belt, then I recommend that you return it and order this one.

 

If you have the correct belt, then I recommend that you check the routing of the belt over the motor pulley and around the idler pulley. The first image below shows how the belt should be routed. I added a procedure for accessing and replacing the belt in the second image.

 

This information should help you fix that dryer problem. If you need more assistance, reply with additional details.


I understand that you are trying to fix this problem on your own. If you do get to the point where you need to have a service technician examine the dryer and install the belt, you can schedule service through this link: Sears Home Services Dryer Repair. 

Read More
Lyle W -
Sears Technician
February 26, 2013