Model #BAR 5 Fridgette compact refrigerator

  • Cabinet And Unit Parts
    3 Results
  • Controls
    3 Results
  • Shelves And Accessories
    3 Results

Question and Answers

Q:

my sears electric chain saw will not start. Model # 358.341180. 18" bar. I used this saw about 5 times and it worked fine when I last used it in the spring.

A:

Thank you for the question.

I am sorry you are having a problem with the chainsaw. I have looked up the model number you have submitted. Besides having the regular trigger to turn, the saw on it has a chain brake. If the chain brake is engaged, the chainsaw will not start. Make sure the hand guard is pulled back towards the handle. The image below shows the brake. If the saw does not start, you will need a volt ohmmeter to diagnose the saw.

I hope this is helpful. If you need further assistance, please reply below with more details.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears technician. Here is a link that will provide the nearest drop-off locations: Sears Home Services .

Thank you for using Manage my life.

Read More
Mark T -
Sears Technician
November 02, 2011
Q:

Support bar

A:

You should find a plastic catch that is holding the support bar in place. Use a small flat tip screw driver to pry up on the plastic frame to release that catch and pull the support bar out of the right side using some pliers (needle nose pliers will probably work best).

If you need more help, reply with additional details (digital photos of the problem would be helpful).

I you get to point where you need a technician, you can schedule one through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
June 11, 2011
Q:

Bar is stuck.

A:

Thank you for your question and I understand your concern.
 
I added a link to the Operator's Manual and on page 14 it shows how to replace and adjust the bar and chain.
 
Since you have the nuts and the bar clamp/cover removed, you will likely need to turn the adjustment screw to release the tension on the chain. Remove the chain and then the bar should simply pull off the two studs. If the chain is off, you may need to tap on the bar to free it up. If the adjustment screw will not loosen in order to release the tension, you may be turning it the wrong way.
 
If you get to the point where you need to have a service technician fix this problem, you can carry the chain saw into your nearest Sears Repair Center or Sears Store. Here is a link for the Sears Service website that has information on the nearest repair facilities in your area: Sears Home Services.

Read More
Joey S -
Sears Technician
August 19, 2013
A:

Steve; The adjustment screw which is use to tighten and loose the chain will need to be turned to remove the tension on the chain. If the bar does not become loose, use a block of wood and tap on the tip of the bar where the chain comes over the top of the bar. You are tapping the bar towards the engine. If the adjustment screw is stuck, it will have to be loosened so the bar can be slide back towards the engine or you will not likely get the bar loose. If you can't get the chain adjustment screw loosened, I recommend taking the saw in for repair.

Read More
Joey S -
Sears Technician
August 19, 2013
See more answers