Model #BA-4 Sony direct view\digital 27" to 40" tv

  • No Image Available - Wards
    3 Results

Question and Answers

Q:

i have a craftsman lt 4000 m/n 917255580 the black plug that goes into the key switch and i need to know where the 2 red 1 white and 4 black wires go on the ba

A:

Thank you for your question.

I will be happy to assist you. I posted a copy of the wiring diagram below. Click on the image to enlarge it. You will need to follow the red and black wires to see where they come from. Once you know where they come from you can connect them to the switch.

I hope this is helpful. If you need further assistance, please reply below.
Thank you for using Manage my life. Mark.

Read More
Mark T -
Sears Technician
September 11, 2012
Q:

Why is my Kenmore refrigerator making a gurgling sound when the door closes? It only does it in the summer, never winter.

A:

The gurgling noise is nothing to be concerned about. This is a normal operating sound. The gurgling noise is emitting from the defrost drain tube located above the defrost drain pan. The defrost drain tube (key#84) bends upwards right before it ends above the drain pan in order to trap a small amount of water. See image below. This is made this way to prevent air from migrating up the drain tube and into the freezer. It's like a "P" trap under your sink to prevent sewer gases from migrating up the drain pipes into the house. The gurgling is caused by a vacuum that is created inside the refrigerator when ever the door has been open for any length of time and then shut. The warm air drawn into the refrigerator when the door was opened cools and condenses and creates a vacuum which causes air to be drawn up the tube which causes the water sitting in the elbow to gurgle until the inside and outside air pressure equalizes.

Read More
Joey S -
Sears Technician
June 16, 2010
Q:

"hi, I have a #580751350 Craftsman 1500 psi pressure washer - Pump, item #22 seal how do U install it in the back of # 24 guide, the front 1 is easy, but the ba

A:

Thank you for your question.

I can understand that it can be a little difficult to replace some parts on the pressure washer.

When I replace seals on pressure washers I will rub a thin coat of 100% silicone grease on the seals and then start the seal in the location at a slight angle to get them started and then work them into the seat. You could also use Vaseline in a pinch.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
July 15, 2011
A:

Thank you for the update. You would be a great resource for our web site with you well rounded experience. I will forward you information onto Management. Sam A.

Read More
Sam A -
Sears Technician
July 18, 2011
See more answers