Model #ARG7302WW-P1143391NWW Amana free standing, gas

  • Cabinet
    3 Results
  • Cavity
    3 Results
  • Main Top
    3 Results
  • Backguard And Gas Supply
    3 Results
  • Oven Door And Storage Door
    3 Results

Question and Answers

Q:

Model # arg7302ww amana

A:

Thank you for your question.

I can understand wanting the oven to get up to a baking temperature so you can bake.

It is a high probability that he oven sensor is out of calibration. It will not let the oven burner stay on long enough to get up to temperature.

  • I would suggest that you replace the sensor.

You will need a volt/ohm meter to check the sensor.

  • At 75 degrees it should be 1100 ohms. If it is off by more that 10 to 15% you will need to change it.

  • To get to the sensor in the oven cavity first _REMOVE POWER to the range and open the oven door and remove the oven racks.

  • Then locate the oven sensor on the upper back wall of the oven cavity and remove the screws that secure it to the oven.

  • Pull the sensor and harness into the oven cavity and disconnect the sensor and plug in the new sensor.

The part number for the sensor is: Y0314907 and you can purchase it from: Sears Parts Direct .

  • Restore power to the range and test operation.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
February 24, 2011
Q:

amana stove oven won't start

A:

I am sorry to hear about this problem that you are having with your Amana Range Model ARG7302WW.

 

You could have a failed igniter even though that component is glowing according to your details. Here is a link for a video that provides a good explanation of the ignition process in that oven: Gas Ignition Operation

 

Since the igniter glows, this indicates that the other components in that circuit are apparently okay. In this situation, you can likely fix this problem by replacing that igniter.

 

There are several different models that begin with ARG7302WW.  Here is a link for repair parts on the models that begin with those numbers: Amana Range Model ARG7302WW . . . Repair Parts.  

 

Use your full model number to view and order parts for your range. If you need help ordering parts or repairing the range, reply with additional details and we will assist you further.

 

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services Range Repair. 

Read More
Lyle W -
Sears Technician
May 18, 2013
Q:

Clock and controls shuting off when oven heats up

A:

Thank you for your question and I understand your concern.

Without having the complete model number I can only provide general information. The model number should also have another set of numbers following the ARG7302WW. It should start with the letter P and seven other numbers followed by three letters.

I believe the transformer you are speaking of is part of the electronic oven control board. Based on your symptom and details, the transformer could have a loose solder joint where the wire leads are soldered to the board. You will likely have to replace the oven control board.

You can look up and order the parts from Sears PartsDirect . You will also need to order the Mylar overlay that will fit over the new control board.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
January 10, 2013