Model #ADG7005AWW Admiral residential dryer

  • Cabinet & Front Panel
    3 Results
  • Base, Heater & Motor (gas)
    3 Results
  • Supplemental Information
    3 Results
  • Control Panel & Top
    3 Results
  • Tumbler
    3 Results
  • Wiring Information
    3 Results
  • Wiring Information
    3 Results

Question and Answers

Q:

How do I convert my Admiral dryer model ADG7005AWW from natural gas to LP (Propane) gas?

A:

The LP gas conversion should be completed by a qualified installer.

I provided the instruction sheet for this conversion kit in the images below. The orifice spud is shown in the drawing on the top right hand corner of the first image. It is just beside the gas valve coils. You will need to replace this spud to properly convert the dryer to LP gas. This should help you properly convert the dryer. I recommend that you have a gas technician check the installation as well if you are completing this conversion yourself.

Read More
Lyle W -
Sears Technician
November 04, 2009
Q:

Why won't my Admiral gas dryer heat, the thermal fuse is OK?

A:

If the thermal fuse was bad, the motor would not run. I added a wiring diagram and troubleshooting information in the images below. Based on your details you know how to check continuity. You will need to check continuity of each one of the components connected in series with the gas valve assembly. Note: You must disconnect one wire from the component being tested for continuity or you will not get an accurate measurement. You will need to check the following components for continuity:

  • Temperature switch/heat switch
  • Cycling thermostat
  • High limit thermostat
  • Radiant sensor
  • Ignitor
The timer must also supply L1 voltage on the Red wire into the heat switch and out on the Blue (BU) wire to the cycling/operating thermostat. NOTE: I do not recommend checking voltages unless you have experience and feel safe and confident in doing so otherwise I recommend calling a service technician to diagnose and repair your gas dryer.

Read More
Joey S -
Sears Technician
October 27, 2009
Q:

Admiral gas dryer will not heat intermittently

A:

An intermittent heating problem can be difficult to diagnose and repair on your own. Scheduling service is a risk as well in this type of situation. If the technician visits while the dryer is heating normally, then he may not be able to diagnose and repair your failure.

I recommend that you check these issues:

  • Make sure that you have an adequate gas supply provided to the dryer.
  • When the dryer fails to heat, check to see if the igniter is glowing. If the igniter is glowing then the operating thermostat and the high limit thermostat are apparently okay. If the igniter glows and then fades of regularly while the dryer is running in heated cycle then you could have weak gas valve coils.
  • If the igniter glows but never fades off then you could have a weak igniter or a bad flame sensor.
  • If the igniter is not glowing in a heated cycle then you could have a bad operating thermostat or a bad high limit thermostat. A number of other failures could prevent the igniter from glowing.


These general tips may help you with this failure. If you need more assistance, reply with additional details regarding the condition of the igniter when the dryer won't heat.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
October 29, 2012
A:

Hello Kent. Thanks for letting us know what you found. We are glad to hear that the dryer is fixed. Let us know if you ever need more assistance.

Read More
Lyle W -
Sears Technician
December 13, 2012
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show