Model #A42-10 Gmc air handler (indoor blower&evap)

  • Air Handler
    3 Results

Question and Answers

Q:

I have a42" Craftsman mower, model # 917.270821. Will a model 917.249890 42" bagger fit this model?

A:

Thank you for your question.



I will be happy to assist you. I looked up the model numbers you submitted. The bagger will fit the tractor.



I hope this is helpful. Please let me know if you need further assistance.



Thank you for using Manage my life.

Mark.

Read More
Mark T -
Sears Technician
August 07, 2012
Q:

F 10

A:

Thank you for your question and I understand your concern.

The "F10" fault code indicates a runaway temperature. This could be caused by a faulty oven temperature sensor probe or a faulty electronic oven control. The oven temperature sensor should be removed, disconnected and tested for proper resistance using an Ohm meter. The oven sensor is located inside the oven cavity in the rear upper rear left or right hand corner. If the screws are visible from inside the oven cavity, it can be removed from inside the cavity. If you do not see screws, the wall oven will have to be removed and the rear panel in order to access and remove the oven temperature sensor.

Use the RTD scale I added in the image below for the resistance scale.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post along with the model number. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
April 20, 2012
Q:

10'' radial saw

A:

Thank you for your question.

 

I am sorry you are having this problem with the radial arm saw. Usually when a saw does not start but hums and turns slow, it is because the start switch on the motor is not working or the capacitor is defective. Before you take the motor apart, I recommend plugging the saw directly into an outlet. Then check the operation. If it still does not work, I recommend unplugging the unit and remove the plastic cover over the motor. The capacitor is installed on the top of the motor. It is a cylinder shaped part that has a few wire attached to it. If you have a local electrical supply house, you can remove the capacitor and bring it to them. They should be able to test the capacitor. If it checks ok, the problem is likely the start switch on the motor shaft opposite of the blade. If you have an ohmmeter, you can remove the switch and test it. It should show closed or 0 ohms when pushed and ol or open when released. If you do not have these readings, the switch is defective. The parts can be ordered from the following link. Replacement parts for a Craftsman radial arm saw model 113.199250.

If the switch checks out fine, the problem is likely in the start windings. I looked up the stator and I am sorry it is no longer available. If the saw does need the stator, you might be able to find a local motor company to rewind it for you.

 

 

I hope this is helpful. Please let me know if you need further assistance.

 

Thank you for using Manage my life.

 

Mark T.

Read More
Mark T -
Sears Technician
October 21, 2013