Model #WFW9400SZ02 WHIRLPOOL Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Dispenser Parts
    3 Results
  • Tub And Basket Parts
    3 Results
  • Pump And Motor Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

can not start or run the washer WFW9400SZ02 Whirlpool Residential washer

A:

The other question that you asked indicated that you are seeing the F32 error code. I provided advice on clearing that code in my answer to your other question. Here is a link for that answer: http://www.searspartsdirect.com/partsdirect/questionDetail/371894

 

If you need more help, let us know. 

Read More
Lyle W -
Sears Technician
November 20, 2013
Q:

The washer will not start? appeared F32 WFW9400SZ02 Whirlpool Residential washer

A:

That F32 code indicates that the control is not getting a signal through the water level pressure switch (part 8181695). Unplug the washer and remove the top panel to access that water level pressure switch. Screws at the very back of the top panel have to be removed to release it from the washer frame. You can then pull back slightly on the top panel to release the front lip and lift it off of the machine. Check the wire harness connections between the water level pressure switch and the main machine control board. If the wire harness connections are okay, then you will probably need to replace that water level pressure switch. If that does not fix the problem, then the main machine control board will also have to be replaced.

 

If you need more help, let us know. 

Read More
Lyle W -
Sears Technician
November 20, 2013

Top Parts