Model #VBA2-9.6 ICP Air-conditioner/heat pump(outside unit)

  • Unit Parts
    3 Results
  • Guarantee
    3 Results
Find part by diagram >

Question and Answers

Q:

I have a 9.6 craftsman drill when I plug in charger no lites come on for either batterys

A:

Thank you for your question and I understand your concern.

If the two batteries are good, then I would have to suspect a faulty charger providing the charger is plugged into working power outlet. I recommend taking the drill, batteries and the charger to a Sears store or the nearest Sears service center and have them test the batteries and the charger unless you have a voltage meter to test the battery voltage and the output of the charger.

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post along with the model number of the drill. If you get to the point where you need to have a service technician fix this problem, you can carry the drill, batteries and charger into your nearest Sears Repair Center or Sears Store. Here is a link for the Sears Service website that has information on the nearest repair facilities in your area:Sears Home Services.

Read More
Joey S -
Sears Technician
July 15, 2013
Q:

I need staples for my Craftsman 9.6 volt cordless stapler. model # 836.272350

A:

Thank you for your question.

 

I will be happy to assist you. I looked up the model number you submitted. I could not find a manual for this model. The best I can tell is the stapler uses T50 or compatible staples. I recommend taking the stapler to the store with you. Then test fit the staples to be sure they fit.

 

I hope this is helpful.  

 

Thank you for using Manage my life.

 

Mark T.

Read More
Mark T -
Sears Technician
October 25, 2013
Q:

bought new Bushwacker 9.6 v battery, charged on existing charger but battery will not release now that it is charged. help

A:

I know that it can be very difficult to have your battery stuck in your charger. This can only happen if apart of the battery is caught on something or if the battery and charger have melt together (very rare). I would suggest that you unplug the charger and give it time to cool down, then try an pull out the battery. If you can not get it out, then you will need to replace the charger and the battery. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
August 23, 2012