Model #U4671-930 HOOVER Vacuum, Upright

  • Vacuum Assembly
    3 Results
  • Motor
    3 Results
Find part by diagram >

Question and Answers

Q:

Attachment for drive control system for self propelled mower model #917 371 930/

A:

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
May 10, 2011
Q:

How do I install a lift switch on my treadmill?

A:

The switch plugs into the console and has spring retainers to hold it in place. Look at the new switch and see where the retainers are.

Disconnect the power to the treadmill, use a small screwdriver or a putty knife to pry the old switch out of the console.

Remove the wires from the old switch and install them on the new switch. Push the new switch into the opening in the console until it snaps in place.

Read More
Jimmy K -
Sears Technician
November 06, 2009
Q:

My Kenmore Series 90 Washing Machine model #23922200, S/N: CM3717 930, type 111; in all cycles, the washing machine fills with water but does not cycle.

A:

Thank you for your question.

I am sorry you are having a problem with your washer. If the washer will agitate but never drains and spins, I suspect the lid switch is the problem. If the lid switch is not closed or is defective, the washer will not drain or spin.

A quick check you can do is to run a cycle with the lid switch jumped. If the washer operates, the lid switch needs to be replaced.

To jump the lid switch you need to unplug the washer and open the console. I have provided you with the instructions for opening the console below. Once you have the console open, locate the connector for the lid switch. Place an insulated jumper between the gray and tan wires. Not the green it is a ground and will cause a short. After inserting the jumper make sure it will not touch anything metal, plug the washer in. Then start the washer in a cycle, and let it go. If the washer completes the cycle, you need to replace the lid switch. Do not leave the jumper in while you are waiting for the part. The jumper is only of the test.

To you replace the lid switch you have to remove the cabinet of the washer. The instructions for that are also in the image below. Once the cabinet is removed you can take the screws out securing the lid switch and remove the harness from the clips along the underside of the cabinet. Then reinstall the lid switch in the reverse order. Before you reassemble the cabinet, please read the instructions for installing the cabinet provided in the image.

I hope this is helpful. Please reply below if you need further assistance. Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
December 31, 2010