Model #U31FK-92X-AC MAGIC CHEF Range (gas)

  • Control Panel
    3 Results
  • Body
    3 Results
  • Control System
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

ac

A:

Thank you for your question.

I will assist you with your question. Air conditioners today are not made to drain all of the water out of the base. The condenser fan will sling water from the base onto the condenser to aid in cooling. If the water seems to be at a higher level than it did before I recommend checking the drain at the back of the unit. It might be plugged with debris. If the water is leaking into the house, I recommend checking the level of the unit. It should be at least a 1/4 inch lower in the back than the front.

I hope this is helpful.

Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
July 19, 2011
A:

John Collins,

I am sorry you are having a problem with the room ac unit. I looked up the manual for this unit. According to the manual, this unit has a drain tank. The image below shows how to empty it. If you still have a leak, I recommend checking the installation of the ac. The link below will take you to the manual that has the instructions. If it is installed correctly, I suspect the drain is plugged or the catch pan is broken. You will need to take the unit apart to check these.
Please let me know if you need further assistance.
Mark T.

Read More
Mark T -
Sears Technician
August 19, 2012
See more answers
Q:

heat and ac

A:

Based on the improvements that you intend to make, I recommend that you contact a LEED certified builder and examine the options for heating and cooling your home. Many factors will need to be considered in determining the best solution. A building contractor will be able to provide specific advice.

The ServiceLive.com website has contractors in many areas of Florida that can complete some (or all) of the work that you are describing. You may also want to get some estimates from Sears Home Improvement for the work that you intend to complete. Here is a link for the Sears Home Improvement website: Sears Home Improvement .

Read More
Lyle W -
Sears Technician
July 30, 2010
Q:

window ac fried 25370125001 kenmore window ac

A:

The technical data for that model of air conditioner shows that it uses 220 volts but the replacement power cord is listed as a 110 volt outlet cord. If the air conditioner has a 220 volt outlet cord as the original part then the air conditioner likely needs 220 volts to operate. I looked at the replacement electronic control board (part 309350402). That control board has an L2 connection spade on the control board which indicates that the board and air conditioner use 220 volts of power. If the air conditioner uses 220 volts of power, then you could have a bad transformer or a failed electronic control board. 

If the air conditioner is actually a 110 volt model, then you likely fried the transformer, electronic control board and/or wiring when you plugged the unit into a 220 volt outlet. 

I hope that this information helps. 

If you need more assistance, let us know.

Thanks for choosing Sears PartsDirect.

Read More
Lyle W -
Sears Technician
August 03, 2015