Model #TS-W100 AIWA Speakers

  • Cabinet Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

How to repair my Maytag dryer with a tS fault code?

A:

The error code is actually a tS which indicates a shorted thermistor or the thermistor has a very low resistance.

First, check for a clogged lint filter screen, restricted venting system and then the thermistor would need to be tested with an ohm meter.

The thermistor should have a resistance reading of 10K ohms at 77 degrees. The thermistor and thermistor circuit can be measured from the control board. Disconnect the Red and Blue wires from the control board located next to each other at CN6 connector. You will need a volt/ohm meter to ohm the resistance across the Red and Blue wires. If the resistance does not measure 10,000 ohms at room temperature of near 77 degrees, replace the thermistor.

I added three (3) images with information and instructions.

Part#3500119 (thermistor) which is located on the blower housing.

I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
September 11, 2008
Q:

Why is my Kenmore Elite range model 790 range beeping and flashing "ts" in red?

A:

Without the full model number of your range, it is difficult to predict the cause of the "ts" in the display. I checked the general information for fault codes on this type of range. I do not find information on this code in the display. It could be an operating code that is covered in your owner's manual. Resubmit your question with the full model number and we will research this issue further.

You can normally find the full model number of this type of range on a plate that is located on the base of the range in front of the right front leveling leg. You need to pull the bottom drawer out to view this area.

Read More
Lyle W -
Sears Technician
Q:

Were is my order? I ordered on 11-6-11 now ts the 11-18-11 and no item of emails with Info.

A:

Thank you for your question on the order you are waiting for.

I see that Jackie S. has given you some information on the status of your order and I hope you will be receiving your item soon.

Sam A.

Read More
Sam A -
Sears Technician
November 21, 2011