Model #TMO-190-831-000 MTD snowthrower, gas

  • 31" Dump Sweeper
    3 Results
  • 31" Dump Sweeper Page 2
    3 Results
  • 31" Dump Sweeper Page 3
    3 Results
  • 31" Dump Sweeper Page 4
    3 Results

Question and Answers

Q:

panel lights out 831 297190

A:

Thank you for your question.

I am sorry you are having a problem with the treadmill. I looked up the model number you submitted. The console on this model requires batteries for the console to light up. I posted an image below that contains the instructions for installing the batteries. If you already installed new batteries and the console will not light up I recommend pushing the on/rest button. If it still does not come on the console is defective. To repair this, the console needs to be replaced. I looked up the part number for the console and the part is no longer available. If it ends up needing a console, you can search for one online.

I hope this is helpful. If you need further assistance, please reply below with more details.

Thank you for using Manage my life. Mark T

Read More
Mark T -
Sears Technician
December 03, 2012
Q:

What type of oil do I use for Craftsman Pressure Washer model# 580-750193

A:

Thank you for your question.

I am sorry but the model number you have submitted did not pull up for me. I do not want to give you information from a different model because not all the pressure washers use the same oil. The pressure washer has oil in the engine and the pump and they are different. Most engines use SAE30 motor oil. If you could please double check, the model number and specify if you need the information for the pump or the engine.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
October 04, 2010
Q:

I have a Pro-Form 730 Treadmill. Is it easy for DIYer's to replace the left and right link arms?

A:

Replacing the link arms is fairly simple if you have the right tools and some patience. You will have to remove the nut on the inside of the treadmill frame that holds the upright frame to the treadmill. Spread the upright and remove the slider and washers for the link arm.

There are several spacers and washers involved that will fall off as you remove these parts. You have to get them back in their correct places.

Read More
Jimmy K -
Sears Technician
November 21, 2008